Simulation and Design of an Organic Quantum Film Electrooptic Switch
Authors
Abstract:
In this paper the simulation and design of a quantum-film electro-optic switch is considered. This photonic device, is made from a new organic dipolar material called MNA or 2-methyl-4 nitroaniline, which possesses a high merit in comparison with it's inorganic counterparts (e.g. LiNbO3, GaAs, InSb, Quartz, etc). Montecarlo method is used to simulate the photon-it-electron interaction in this material and the introduced physical model is based on wave-particle nature of light to demonstrate the Pokiels' Electro-optic effect in M7NA optical switch. The main advantages of this design are wide optical bandwidth (0.5-2 microns wavelength), low power consumption and high speed data transmission.
similar resources
simulation and design of electronic processing circuit for restaurants e-procurement system
the poor orientation of the restaurants toward the information technology has yet many unsolved issues in regards to the customers. one of these problems which lead the appeal list of later, and have a negative impact on the prestige of the restaurant is the case when the later does not respond on time to the customers’ needs, and which causes their dissatisfaction. this issue is really sensiti...
15 صفحه اولdesign of an analog fuzzy logic controller chip
fuzzy logic has been developed over the past three decades into a widely applied techinque in classification and control engineering. today fuzzy logic control is one of the most important applications of fuzzy set theory and specially fuzzy logic. there are two general approachs for using of fuzzy control, software and hardware. integrated circuits as a solution for hardware realization are us...
15 صفحه اولDesign and Simulation of an X Band LC VCO
In this paper, a systematic method for the circuit parameters design of a monolithic LC Voltage Controlled Oscillator (VCO) is reported. The method is based on the negative resistance generation technique. As a result, a VCO has been designed in 0.18um CMOS technology using a conventional VCO structure to obtain the optimum values for the phase noise and power consumption. The simulation result...
full textDesign and simulation of a RF MEMS shunt capacitive switch with low actuation voltage, low loss and high isolation
According to contact type, RF MEMS switches are generally classified into two categories: Capacitive switches and Metal-to-Metal ones. The capacitive switches are capable to tolerate a higher frequency range and more power than M-to-M switches. This paper presents a cantilever shunt capacitive RF MEMS switch with characteristics such as low trigger voltage, high capacitive ratio, short switchin...
full textElectrooptic modulation in thin film barium titanate plasmonic interferometers.
We demonstrate control of the surface plasmon polariton wavevector in an active metal-dielectric plasmonic interferometer by utilizing electrooptic barium titanate as the dielectric layer. Arrays of subwavelength interferometers were fabricated from pairs of parallel slits milled in silver on barium titanate thin films. Plasmon-mediated transmission of incident light through the subwavelength s...
full textHybrid organic/quantum dot thin film structures and devices
Organic light emitting diodes have undergone rapid advancement over the course of the past decade. Similarly, quantum dot synthesis has progressed to the point that room temperature highly efficient photoluminescence can be realized. It is the purpose of this work to utilize the beneficial properties of these two material sets in a robust light emitting device. New deposition techniques are nec...
full textMy Resources
Journal title
volume 8 issue 4
pages 191- 198
publication date 1995-11-01
By following a journal you will be notified via email when a new issue of this journal is published.
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023