Tungsten inert gas (TIG) welding, also called as gas tungsten welding 1. (a) Schematic of TIG welding Process (b) Variety of tungsten electrodes. The activated TIG (ATIG) welding process mainly focuses on increasing the depth of penetration and the reduction in the width of weld bead has not been paid. Tungsten inert gas welding, TIG is widely applied in manufacturing process for different The ...

Gas tungsten arc welding (GTAW) or Tungsten inert gas welding (TIG) is one of the widely used techniques for joining ferrous and non-ferrous metal.Gas tungsten arc welding process,consist of non-consumable tungsten electrode which is used to provide the arc for welding. During the welding cycle a shield of inert gas expels the air from the welding area and prevents oxidation of the electrode, w...

This paper provides a general introduction to welding fundamentals (section 2) followed by sections on a few selected welding processes that have had significant developments or improvements over the last few years. The processes that are discussed are friction welding (section 3), hot plate welding (section 4), ultrasonic welding (section 5), laser/IR welding (section 6), RF welding (section 7...

Submerged arc welding is preferred over other methods of welding because of its inherent qualities like easy control of process variables, high quality, deep penetration, smooth finish, capability to weld thicker sections. Since the development of submerged arc welding process, welding engineers are striving for reduction in welding cost without compromise in the performance of the weld. Flux u...

In this study, the effect of various welding parameters on the weldability of Mild Steel specimens having dimensions 50mm× 40mm× 6 mm welded by metal arc welding were investigated. The welding current, arc voltage, welding speed, heat input rate are chosen as welding parameters. The depth of penetrations were measured for each specimen after the welding operation on closed butt joint and the ef...

The objective of this study was to characterize personal exposures to welding-related metals and gases for production welders and non-welders in a large manufacturing facility. Welding fume metals and irritant gases nitrogen dioxide (NO2) and ozone (O3) were sampled for thirty-eight workers. Personal exposure air samples for welding fume metals were collected on 37 mm open face cassettes and ni...

Laser beam welding has wide acceptability due to least welding distortion, low labour costs and convenient operation. However, laser welding for dissimilar titanium and aluminium alloys is a new area which is having wider applications in aerospace, aircraft, automotive, electronics and other industries. The present study is concerned with welding parameters namely laser power, welding speed, fo...

Tungsten Inert Gas welding (TIG) process is an important component in many industrial operations. The TIG welding parameters are the most important factors affecting the quality, productivity and cost of welding. This paper presents the influence of welding parameters like welding current, welding speed on strength of low carbon steel on AA1050 material during welding. A plan of experiments bas...

Studies in the field of environmental epidemiology indicate that for the adverse effect of inhaled particles not only particle mass is crucial but also particle size is. Ultrafine particles with diameters below 100 nm are of special interest since these particles have high surface area to mass ratio and have properties which differ from those of larger particles. In this paper, particle size di...

The present study shows the relationship between welding quality and optical-acoustic emissions from electric arcs, during welding runs, in the GMAW-S process. Bead on plate welding tests was carried out with pre-set parameters chosen from manufacturing standards. During the welding runs interferences were induced on the welding path using paint, grease or gas faults. In each welding run arc vo...