in this research, b4c-ni cermet coating was sprayed on the surface of 4130 steel from b4c and ni feed-stockpowders using high velocity oxy-fuel (hvof) method. in order to characterize the tribological behavior of thecoating, ball on disk wear tests were done at the ambient temperature and under the loads of 1, 3 and 5 n.phase analysis of the coating after spraying was studied by x-ray diffracto...

A new wear testing system, which carries out toothbrush wear and simulated occlusal wear tests alternately, was developed. Differences in wear behavior among three modes of wears, combined wear, toothbrush wear and simulated occlusal wear, were investigated using polymethylmethacrylate (PMMA) and two commercial resin composites (Z100, APX). The area of the material loss after each test was meas...

researchers suggested that the individual fit test be conducted to estimate the protection effectiveness of workers’ hearing protection device (hpd) while working. practically, it is convenient to conduct single, instead of multiple, fit test measurement. this study examined if a single trial of earplug fit test can represent multiple performances. additionally, it investigated how much noise e...

functionally graded aluminium/zirconia metal matrix composite was fabricated using stir casting technique followed by horizontal centrifugal casting process and a hollow cylindrical functionally graded composite (150 x 150 x 16 mm) was obtained with centrifuging speed of 1200 rpm. the microstructural evaluation and hardness test was carried out on the outer and inner surface of the functionally...

ti-6al-4v titanium alloy has great application in medicine and military industries due to its capabilities, namely high strength to weight ratio and corrosion resistance. in the current research, the effect of aging treatment on microstructure and wear behavior of ti-6al-4v titanium alloy was investigated. pin on disk wear test was applied to assess the wear behavior. specimens were first solut...

In the present study, enamel wear against indirect composite resins was evaluated using two newly designed wear test methods: a rotating sliding wear test and a buff wear test. For the composite resins investigated in this study, their surface morphologies were examined using a scanning probe microscope after buff-polishing. After the wear tests, enamel was worn down by hard fillers that protru...

In the present study, an investigation into wear properties has been carried out to identify the influence of ZrO2 as the reinforcement material on the LM25 MMC composite. Aluminum LM25 is selected as the base material, and it is reinforced with varying proportions of 0, 3, 6, 9, 12 and 15% of zirconia (ZrO2) manufactured by stir casting. Six tensile test and wear test samples were prepared acc...

In gears running under conditions of high load and low circumferential speed the lubricant film thickness is often not sufficient to fully separate the mating surfaces. Wear of the gear flanks can occur and can even result in total gear failure. For a given gear geometry the main influencing parameters are load, circumferential speed and lubricant. The wear characteristics of lubricants depend ...