the purpose of this paper is to studying nonlinear k-ε turbulence models and its advantages in internal combustion engines, since the standard k-ε model is incapable of representing the anisotropy of turbulence intensities and fails to express the reynolds stresses adequately in rotating flows. therefore, this model is not only incapable of expressing the anisotropy of turbulence in an engine c...

The purpose of this paper is to studying nonlinear k-ε turbulence models and its advantages in internal combustion engines, since the standard k-ε model is incapable of representing the anisotropy of turbulence intensities and fails to express the Reynolds stresses adequately in rotating flows. Therefore, this model is not only incapable of expressing the anisotropy of turbulence in an engine c...

to enhance the understanding of the impact of obstacle buildings on pollution transportationand dispersion in the atmospheric boundary layer, it is necessary to know the atmospheric flow characteristics over terrains. wind flow characteristics in a boundary layer over a step-shaped cliff topography model with rough and smooth surfaces were studied numerically using computational fluid dynamics ...

In this study, turbulent compressible gas flow in a rectangular micro-channel is numerically investigated. The gas flow assumed to be in the subsonic regime up to Mach number about 0.7. Five low and high Reynolds number RANS turbulence models are used for modeling the turbulent flow. Two types of mesh are generated depending on the employed turbulence model. The computations are performed for R...

to enhance the understanding of the impact of obstacle buildings on pollution transportationand dispersion in the atmospheric boundary layer, it is necessary to know the atmospheric flow characteristics over terrains. wind flow characteristics in a boundary layer over a step-shaped cliff topography model with rough and smooth surfaces were studied numerically using computational fluid dynamics ...

In this study, modeling of a fuel jet which has been injected by high pressure into a low-pressure tank are investigated. Due to the initial conditions and the geometry of this case and similar cases (like CNG injectors in internal combustion engines (ICE)), the barrel shocks and Mach disk are observed. Hence a turbulence and transient flow will be expected with lots of shocks and waves. Accord...

in this paper, the accuracy of k- and k- turbulence models in super sonic boundary layer capturing of smooth/rough flat plates have been comprehensively investigated. among these investigations, some sorts of sensitivity analysis, including change in turbulence model, generated-grid density, near wall affects, c magnitude (for boundary layers generated on smooth flat plates), and change in c...

Roughness elements or turbulence promoters have been widely used to enhance heat transfer in cooling passages of modern gas turbine blades. Although such ribs substantially enhance heat transfer, the heat transfer coefficient is reduced immediately at corner downstream of each rib, creating hot spots. To remove such hot spots some of the ribs can be detached from the channel walls. In this pape...

The drops are used to control the descents,  stabilize the bed level, and control the upstream water level in sloping channels with less slope than the ground slope. The current study presents a numerical analysis of hydraulic characteristics in the vertical drop using computational fluid dynamics. At first, the laboratory models were used for verification and choosing the best model of turbule...