in the present work, the effect of aluminum content, austenitizing temperature and austempering time and temperature on the mechanical properties and hardness of fe-c-al grey cast iron was investigated. for this purpose, three alloys containing 1, 2 and 4 weight percent of aluminum were provided. the tensile samples were austenitized at 850?c and 900?c for 120 min, followed by austempering proc...

Three different aluminum–iron alloys were produced by electron-beam deposition with the iron content in the range 1.15–1.71 at.%. These alloys did not contain any identifiable iron-bearing particles, and exhibited full density with high-angle grain boundaries in the micrometer range, and a sub-grain size typically smaller than 100 nm. The tensile deformation characteristics of the alloys were e...

The corrosion behaviour of three new non-toxic titanium alloys for use as biomaterials has been investigated. The corrosion current densities of these Ti alloys have low values, indicating a passive state that is stable with time. These values were calculated by using both direct and alternate current methods. The comparison with Ti–6Al–4V, widely used as biomaterial, shows slightly lower corro...

Continuing our work on understanding the oxidation behavior of multiphase composite alloys based on the Mo-Si-B system, we investigated three alloys in the Mo-Si-B system, designated as A1, A2, and A3. The nominal phase assemblages of these alloys are: A1 = Mo5Si3Bx (T1)-MoSi2-MoB, A2 = T1Mo5SiB2 (T2)-Mo3Si, and A3 = Mo-T2-Mo3Si. Our previous work showed that for exposures to 1100°C, all alloys...

For past several years, precious alloys have been gradually replaced by non-precious ones in the dental casting field because of the rising price of dental alloys. In Japan during the past ten years, nickel-chromium alloys have been used extensively for crown or bridge and porcelain-fused-to-metal restorations instead of gold or silver alloys. This tendency seems to be the same all over the wor...

A physically-based model for the electrical conductivity of peak aged and overaged Al-Zn-Mg-Cu (7xxx series) alloys is presented. The model includes calculations of the η and the S phase solvus (using a regular solution model), taking account of the capillary effect and η coarsening. It takes account of the conductivity of grains (incorporating dissolved alloying elements, undissolved particles...

Nine Al-(1-3)Mg-(0-0.4)Cu-0.15Si-0.25Mn (in wt%) alloys with potential applications in both packaging and automotive industries have been investigated. Tensile testing showed that solution strengthening is in good approximation linearly proportional to the Mg content. Mechanical testing and microstructural examinations of aged samples indicate that Mg2Si phase precipitates contribute to age har...

OBJECTIVES The aims of this study were to quantify the metallic ions released by various dental alloys subjected to a continuous flow of saliva and to estimate the nutritional and toxicological implications of such a release. METHODS Four pieces of three nickel-based, one noble, one high-noble and two copper-aluminum alloys were cast and then immersed in a continuous flow of artificial saliva...

Development of new biodegradable implants and devices is necessary to meet the increasing needs of regenerative orthopedic procedures. An important consideration while formulating new implant materials is that they should physicochemically and biologically mimic bone-like properties. In earlier studies, we have developed and characterized magnesium based biodegradable alloys, in particular magn...