cold roll-forming is a process in which the roll of sheet is formed by passing continuously through the set of rotary rollers without changing thickness in a cool way until it is formed to the desired profile. in this paper a parametric study on the section twist angle in roll-forming the non-symmetric channel is presented, using finite element simulation. at first finite element simulation res...

in this paper, collapse behavior of simple and reinforced thin-walled channel- section beams, subjected to three- point bending, is investigated. many simple channel- section beams of different geometry and some reinforced ones were tested, and their strengths after collapse were obtained thoroughly. since the available theories in this area are complicated and little attention has been paid to...

In this paper, collapse behavior of simple and reinforced thin-walled channel- section beams, subjected to three- point bending, is investigated. Many simple channel- section beams of different geometry and some reinforced ones were tested, and their strengths after collapse were obtained thoroughly. Since the available theories in this area are complicated and little attention has been paid to...

In this paper, collapse behavior of simple and reinforced thin-walled channel- section beams, subjected to three- point bending, is investigated. Many simple channel- section beams of different geometry and some reinforced ones were tested, and their strengths after collapse were obtained thoroughly. Since the available theories in this area are complicated and little attention has been paid to...

deformation length is one of the most important parameters in cold roll-forming process, which plays a fundamental role in determining the inter-distance between the stations and rate of deformation. deformation length was first introduced by bhattacharyya. he also obtained a closed-form relation for this length in roll-forming of symmetric channel section. in this paper, deformation length in ...

In this paper, the optical properties of one dimensional fractal structures are investigated. We consider six typical fractal photonic structures: the symmetric dual cantor-like fractal structure, the asymmetric dual cantor-like fractal structure, the single cantor-like fractal structure, the symmetric dual golden-section fractal structure, the asymmetric dual golden-section fractal structure a...

in future high-speed self-routing photonic networks based on all-optical time division multiplexing (otdm) it is highly desirable to carry out packet switching, clock recovery and demultplexing in the optical domain in order to avoid the bottleneck due to the optoelectronics conversion. in this paper we propose a self-routing otdm node structure composed of an all-optical router and demultiplex...

This paper applies an evolutionary algorithm, the particle swarm optimization (PSO), to design the optimum open channel section. Depth, channel side slope and bottom width are considered as the variables for rectangular, triangular and trapezoidal channels, respectively. The objective function is minimizing the construction cost of the channel section. MATLAB software is used for programming an...

This paper outlines a novel approximate solution for determining the pressure drop of laminar, single-phase flow in slowly-varying microchannels of arbitrary cross-section. The proposed analysis is general and applicable to symmetric and asymmetric microchannel cross-sections, as examples compact relationships are reported for elliptical and rectangular shapes for three common wall profiles of ...

Abstract Curved channels with constant cross sections are constructed which support a trapped surface wave. Since corresponding eigenvalues embedded in the continuous spectrum of water wave problem and therefore possess natural instability, construction procedure requires “fine-tuning” several parameters (small) curvature channel as well geometrical restrictions on section. In particular, mirro...