recent developments in nanostructured products draw considerable attention to ultrafine grained materials. these materials are normally manufactured by different severe plastic deformation (spd) methods. in the present study, analytical models and finite element method (fem) are used to calculate strain imposed to a specimen that was deformed by equal channel angular pressing (ecap). in additio...

The effect of geometrical parameters involved in vortex extrusion (VE) die design, on AA1050 aluminium alloy processed by VE were investigated using finite element analysis (FEA) and response surface methodology (RSM). For this, VE die length (L), reduction in area (RA), twist angle , and position of control points in Beziers' formulation (C1) were considered as input parameters and strain inho...

Recent developments in nanostructured products draw considerable attention to ultrafine grained materials. These materials are normally manufactured by different severe plastic deformation (SPD) methods. In the present study, analytical models and finite element method (FEM) are used to calculate strain imposed to a specimen that was deformed by equal channel angular pressing (ECAP). In additio...

Production of lightweight metals with a higher strength to weight ratio is always the main goal of researchers. In this article, equal channel multi angular pressing (ECMAP) process as one of the most appealing severe plastic deformation (SPD) methods on production of ultra-fine grained (UFG) materials studied. Two main routes A and C investigated by FEM and compared with each other from differ...

etiology of the ACL. To provide the data for testing this hypothesis, liquid mercury M. L. Hull 1 strain gages were installed on both the anteromedial (AMB) and posterolateral Professor of Mechanical Engineering (PLB) bundles of the ACL of ten specimens, which were then subjected to passive and Chair of Biomedical Engineering, flexion/extension, hyperextension moment, anterior force, internal a...

Tubular channel angular pressing (TCAP) is a recently invented novel severe plastic deformation technique for producing UFG tubes. Plastic deformation analysis using the finite element method (FEM) was carried out to investigate the effects of trapezoidal channel geometry on strain inhomogeneity index (SII), strain level and required load compared to previously used channel geometries. The resu...

This paper models hot compression testing using a dilatometer in loading mode. These small-scale tests provide high throughput at low cost, but are susceptible to inhomogeneity due friction and temperature gradients. A novel method is presented for correcting the true stress-strain constitutive response over full range of temperatures, strain-rates strain. The nominal from used predict offset c...

The material properties of articular cartilage are depth-dependent, i.e. they differ in the superficial, middle and deep zones. The role of this depth-dependent material inhomogeneity in the poromechanical response of the knee joint has not been investigated with patient-specific joint modeling. In the present study, the depth-dependent and site-specific material properties were incorporated in...