in this paper, the problem of turbulent forced convection flow of water- alumina nanofluid in a uniformly heated pipe has been thoroughly investigated. in numerical study, single and two-phase models have been used. in single-phase modeling of nanofluid, thermal and flow properties of nanofluid have been considered to be dependent on temperature and volume fraction. effects of volume fraction a...

this paper presents the effect of high viscosity oil and two-phase foamy-oil flow on the performance of a single stage centrifugal pump. as a part of this, the applicability of a pipe viscometer to determine the foamy oil viscosity is investigated. unlike previous studies, a sealed fluid tank is used in a closed flow loop to allow conditioning the two-phase mixture to create foamy-oil. furtherm...

computational fluid dynamics analysis was employed to investigate the radial flow field patterns of proton exchange membrane fuel cells (pemfc) with different channel geometries at high operating current densities. 3d, non-isothermal was used with single straight channel geometry. our study showed that new generation of fuel cells with circle stack with the same active area and inlet area gave ...

In this paper, the problem of turbulent forced convection flow of water- alumina nanofluid in a uniformly heated pipe has been thoroughly investigated. In numerical study, single and two-phase models have been used. In single-phase modeling of nanofluid, thermal and flow properties of nanofluid have been considered to be dependent on temperature and volume fraction. Effects of volume fraction a...

This paper presents the effect of high viscosity oil and two-phase foamy-oil flow on the performance of a single stage centrifugal pump. As a part of this, the applicability of a pipe viscometer to determine the foamy oil viscosity is investigated. Unlike previous studies, a sealed fluid tank is used in a closed flow loop to allow conditioning the two-phase mixture to create foamy-oil. Furtherm...

In this paper, the problem of laminar nanofluid flow which results from the nonlinear stretching of a flat sheet is investigated numerically. In this paper, a modified variable physical properties model for analyzing nanofluids flow and heat transfer is introduced. In this model, the effective viscosity, density, and thermal conductivity of the solid-liquid mixture (nanofluids) which are common...

force convection heat transfer of turbulent nano fluid flow in 90 and 60 degree elbow is simulated by using fluent. single phase model has been implemented to study such a flow field and standard

The present work involves numerical simulation of a steady, incompressible forcedconvection fluid flow through a matrix of porous media between two parallel plates at constanttemperature. A Darcy model for the momentum equation was employed. The mathematical model forenergy transport was based on single phase equation model which assumes local thermal equilibriumbetween fluid and solid phases. ...

multiphase flows are commonly encountered in oil and gas industries. the transport of multiphase flow causes the formation of slug, the increase of pressure drop and the possibility of phase changes therefore, a set of simulation runs was performed to predict flow regimes in a horizontal pipeline, and the results were compared with the baker chart. the effects of small downward inclinations of ...

this paper proposes a flexible power electronic transformer (fpet) for the application in the micro-grids. the low frequency transformer is usually used at the point of common coupling (pcc) to connect the low voltage grid and utility network to each other. the conventional 50hz transformer results in enhanced low voltage-grid power management system during grid-connected operation. in this pap...