In the present paper, time dependent creep behavior of hollow circular rotating cylinders made of exponentially graded material (EGM) is investigated. Loading is composed of an internal pressure, a distributed temperature field due to steady state heat conduction with convective boundary condition and a centrifugal body force. All the material properties are assumed to be exponentially graded a...

Oxides of Nitrogen are the major emission from a diesel engine. It is due to heterogeneous diffusion combustion system with fuel-rich regions, which produce high local temperature around the periphery of the spray where high formation rate of NO is promoted. Various techniques are therefore employed to reduce the NOX emission like EGR, SCR, etc. In this present work a rotating injector is a tec...

oxides of nitrogen are the major emission from a diesel engine. it is due to heterogeneous diffusion combustion system with fuel-rich regions, which produce high local temperature around the periphery of the spray where high formation rate of no is promoted. various techniques are therefore employed to reduce the nox emission like egr, scr, etc. in this present work a rotating injector is a tec...

Turbulence studies were made in the wake of a rotating circular cylinder in a uniform free stream. The interest was to examine the turbulence properties at the suppression of periodicity in vortex formation process. An experimental study of the turbulent near wake of a rotating circular cylinder was made at a Reynolds number of 9000 for velocity ratios, λ between 0 and 2.7. Hot-wire anemometry ...

We report three-dimensional direct numerical simulations of the turbulent flow between counter-rotating concentric cylinders with a radius ratio 0.5. The innerand outer-cylinder Reynolds numbers have the same magnitude, which ranges from 500 to 4000 in the simulations. We show that with the increase of Reynolds number, the prevailing structures in the flow are azimuthal vortices with scales muc...

in this study, the characteristics of the wake around a rotating circular cylinder have been investigated experimentally. to this end, a cylinder with a circular cross-section of plexiglas with the length of 400 mm and a diameter of 20 mm have been tested in the wind tunnel. using existing methods, the characteristics of the wake and the drag coefficients of the model in different cases have be...

Rotating cylinders have wide applications in different areas, especially the aerodynamic area. However, the acoustic behaviors of these components have not been widely studied. The generating noise from a spinning cylinder is mainly due to the detached vortices from the leeward of the body. In this study, the large eddy simulation technique is used to simulate the flow field over a three-dimens...

in this work, the steady and laminar mixed convection of nanofluid in horizontal concentric annulus withrotating inner cylinder is investigated numerically. the inner and outer cylinders are kept at constanttemperature ti and to respectively, where ti>to. the annular space is filled with alumina-water nanofluid.the governing equations with the corresponded boundary conditions in the polar coord...

Potential flow over rotating cylinder is usually solved by the singularity method. However,in this paper a mathematical solution is presented for this problem by direct solution of the Laplace’sequation. Flow over the cylinder was considered non-viscous. Neumann and Dirichlet boundaryconditions were used on the solid surfaces and in the infinity, respectively. Because of non-viscous flow,the La...

Results are reported of an experimental investigation into the motion of a heavy cylinder free to move inside a water-filled drum rotating around its horizontal axis. The cylinder is observed to either co-rotate or, counter-intuitively, counter-rotate with respect to the rotating drum. The flow was measured with particle image velocimetry, and it was found that the inner cylinder significantly ...