The main objective of this study is to evaluate the workability of fresh portland cement concrete while it is still in the mixing truck by determining fundamental rheological parameters (plastic viscosity and yield stress). Nine concrete mixtures with different values of yield stress and plastic viscosity were tested in a concrete truck. The measurements made with the truck were based on the ty...

Recycled asphalts were evaluated based on SHRP binder specification. DSR (Dynamic Shear Rheometer) and BBR (Bending Beam Rheometer) tests were carried out on samples of the recycled asphalts under three conditions: original binder, RTFOT (Rolling Thin Film Oven Test) residue and RTFOT+PAV (Pressurized Aging Vessel) residue. PG (Performance-Graded) classification was conducted. New straight asph...

The effects of magnesium stearate (MgSt) and shear stress on flow properties and hydrophobicity are not well known. Blends with different concentrations of magnesium stearate and varying amounts of shear were tested using three different procedures: the FT4 Rheometer test, a tap density analyzer, and the Washburn method, to better understand the relation of lubricant concentration, amount of sh...

In recent decades, the use of self-consolidating concrete has become widespread. Hence, recognizing the various properties of self-consolidating concrete are essential. In this study, several mixture designs have been tested and final mixture design of crushed tile aggregates which were replaced by 0%, 25 %, 50%, and 100% volume percentage of natural aggregates were conducted. To evaluate fresh...

Low-temperature cracking is one of the most common road pavement distress types in Poland. While bitumen performance can be evaluated in detail using bending beam rheometer (BBR) or dynamic shear rheometer (DSR) tests, none of the normalized test methods gives a comprehensive representation of low-temperature performance of the asphalt mixtures. This article presents the Bending Beam Creep test...

Concrete rheological properties need to be properly measured and predicted in order to characterize the workability of fresh concrete, including special concretes such as self-consolidating concrete (SCC). It was shown by a round-robin test held in 2000 [1,2] that different rheometer designs gave different values of viscosity for the same concrete. While empirical correlation between different ...

A rheometer system to measure the rheology of crude oil in equilibrium with carbon dioxide (CO2) at high temperatures and pressures is described. The system comprises a high-pressure rheometer which is connected to a circulation loop. The rheometer has a rotational flow-through measurement cell with two alternative geometries: coaxial cylinder and double gap. The circulation loop contains a mix...

In this study, a powder rheometer was used to measure flow characteristics of two pharmaceutical model powders. Precise measurements were obtained for one of the model powders whereas the results were less precise for the second powder. In conclusion, further work is needed to increase the mechanistic understanding of powder rheological measurements. INTRODUCTION Modern pharmaceuticals are prim...

A novel Three-Point Bending Beam Test (3-PBT) using a Dynamic Shear Rheometer (DSR) with linear drive motor is introduced for testing asphalt binder at low temperature conditions. This 3-PBT in DSR can be used as surrogate (BBR) tests. Advantages comparison to BBR are that (i) works without harmful cooling medium ethanol, (ii) the amount of significantly lower (using material equivalent 10% tes...