the residual activity and air-borne efficacy of etofenprox (trebon 20% wp) were studied on different surfaces in hut scale trial, in kazeroun south of iran, in 1992. the bio-assay contact mortality tests with trebon against anopheles stephensi showed similar responses on pluster, cement and mud surfaces (except wooden surfaces), i.e. at 250, 400 and 500 mg/m2, trebon had residual activity for a...

abstract efficient use and management of organic matter are important aspects of sustainable agricultural. organic matter is relatively low in majority of soils in iran, and continuous use of n fertilizer would create environmental hazards. therefore, the combined use of n fertilizer and organic wastes is an effective strategy. the purpose of this study was investigating of residual effects of ...

Granular residual is created in the banking network when there are a few large banks with many small banks. In this case, the effect of the shocks on each bank not lost in total that can lead to macro-economic consequences. The transmission of monetary policy through change in bank facilities is one of the key mechanisms affecting monetary policies. The power of transmission of monetary policy ...

a greenhouse experiment was conducted using completely randomised design (factorial) with three replications to study the residual effect of organic manures (municipal solid waste compost and cow manure), zinc (0 and 50 kgha-1) and boron (0 and 10 kg.ha-1) by using znso4 and h3bo3 salts respectively, (applied earlier for millet (panicum italicum l.) crop) on soil properties and chemical composi...

introduction: transtibial amputation is the most common amputation in lower limbs. volume loss of residual limb occurs during daily use of prostheses, which results in pistoning between residual limb and prosthetic socket. the goal of this study was to design and fabricate a pneumatic suspension system in transtibial supracondylar prostheses and to evaluate its effect on residual limb pistoning...

the effect of welding residual stresses that was created in thin infill plate of steel plate shear wall system during constructional processes was studied in this research. residual stresses in a welded structure is the result of the non-uniform expansion and contraction and plastic deformation of the weld and surrounding base metal due to heating and cooling cycle, during welding process, this...

Due to the complex geometry and thermos-mechanical loading, cylinder heads are the most challenging parts among all parts engines. They must endure cyclic thermal and mechanical loading throughout their lifetime. Cast aluminum alloys are normally quenched after solution treatment process to improve aging responses. Rapid quenching can lead to high residual stress. Residual stress is one of the ...

there have been some experimental tests on hollow curved-steel struts with thin-walled square sections, in order to investigate their general behavior, particularly their capacity for bearing differing loads. one set of square tubes are cold-formed into segments of circular arcs with curvature radii, equal to 4000 mm. different lengths of curved struts are fabricated so as to cover a practical ...

this research investigates the effect of the post-cure time on the residual stresses in laminated composites. laminated composites were made of t300 carbon fibers and epoxy resin. the post-cure process was carried out at the constant temperature of 120 °c for 6 and 12 hours for two specimens. the slitting method was employed to determine through-thickness residual stress distribution of the com...