in this work dynamic recrystallization behavior of aisi 403 martensitic stainless steel was studied using hot compression tests over temperature range of 900 c -1200 c and strain rate range of 0.001 s-1 - 1 s-1. the obtained flow curves showed that the hot compression behavior of the alloy is controlled by dynamic recrystallization. the flow stress and strain corresponding to the critical, pe...

One of the most promising ways to produce a grain-refined microstructure in some steel materials is the thermomechanical processing route of subcritical recrystallization annealing of a cold-deformed martensite structure. In the present study, the microstructural evolutions and the associated recrystallization kinetics under various subcritical annealing heat treatment conditions are explored i...

The recrystallization behavior of cold-rolled, commercial-purity titanium was studied experimentally and with Monte-Carlo (MC) modeling. Utilization of EBSD-OIM as input for MC modeling resulted in realistic predictions of recrystallization kinetics, microstructure and texture, which were in good agreement with experimental results. MC modeling of recrystallization kinetics predicted that non-u...

In this work dynamic recrystallization behavior of AISI 403 martensitic stainless steel was studied using hot compression tests over temperature range of 900 C -1200 C and strain rate range of 0.001 s-1 - 1 s-1. The obtained flow curves showed that the hot compression behavior of the alloy is controlled by dynamic recrystallization. The flow stress and strain corresponding to the critical, pe...

Tough pitch copper wire (99.97% Cu) is generally characterized by the spiral elongation number. The principle of the test is based on the influence of impurities on the recrystallization kinetics. Alternative non-metallographic techniques to characterize the recrystallization kinetics have been investigated in this study, such as differential scanning calorimetry (D.S.C.) and residual electrica...

A mesoscale model is developed by integrating the rate theory and phase-field models and is used to study the fission-induced recrystallization in U-7Mo alloy. The rate theory model is used to predict the dislocation density and the critical size and density of the recrystallized nuclei due to irradiation. The predicted fission rate and temperature dependences of the dislocation density are in ...

experiments were carried out in which the dependence of the fractional softening on temperature, time and strain rate was determined in a 304h stainless steel. three prestrain ranges were identified pertaining to three different post-deformation softening behaviors: 1) prestraining to below the drx critical strain: strongly strain dependent softening by srx alone with softening kinetics control...

The evaluation of texture as a function of recrystallization has been characterized for directly cold rolled Al-6Mg, Al-6Mg-0.4Sc and Al-6Mg-0.4Sc-0.2Zr alloys. Samples were annealed isothermally at 400 °C for 1 to 240 minutes to allow recrystallization. Recrystallization kinetics of the alloys is analyzed from the micro-hardness variation. Isothermally annealed samples of aluminum alloys were ...

In this paper, the traceability of copper from the anode to the cathode and then the wire rod has been studied in terms of impurity content, microstructure, texture, recrystallization kinetics, and ductility. These characterizations were obtained based on secondary ion mass spectrometry, differential scanning calorimetry (DSC), X-ray diffraction, HV hardness, and electron backscattered diffract...

Recrystallization in copper deformed by dynamic plastic deformation was investigated using electron backscatter diffraction. The recrystallized grains show a broad size distribution. The kinetics of grains of different sizes is observed to be different: In the beginning of recrystallization, the area fraction of small recrystallized grains increases rapidly. At later stages of recrystallization...