circuit of the power supply in pulse width modulated (PWM) voltage inverters results in output voltage deviations. Although individually small, when accumulated over an operating cycle, the voltage deviations are sufficient to distort the applied PWM signal. This paper presents a new method to correct for the dead time deviations. The Pulse Based Compensator is less hardware and software intens...

Nowadays, inverters are power electronics devices used in the renewable energy conversion systems and also to fed induction motors, therefore the continuity of service of power converter has been a major concern. This paper presents a new approach of open circuit fault detection in a pulse width modulation three phase voltage source inverter. The fault occurrence detection was based on the stan...

Soft Switcing techniques have recently been applied in the design of dc-ac converters, in order to achive better performance, higher efficiency, and power density. One of the soft switching techniques uesd in inverters is resonant dc links. These topologies have some disadvantages such as irregular current peaks, large voltage peaks, uncotrollble pulse width, etc. Another soft switching method ...

This letter proposes a behavioral model for analyzing the ground current in medium-voltage (MV) inductors. The impedance between terminals and connection of inductors is measured by analyzer, which capacitive at low frequency. In order to characterize this impedance, multistage paralleled RLC circuit proposed. An analytical method further developed calculate parameters proposed equivalent circu...

Soft Switcing techniques have recently been applied in the design of dc-ac converters, in order to achive better performance, higher efficiency, and power density. One of the soft switching techniques uesd in inverters is resonant dc links. These topologies have some disadvantages such as irregular current peaks, large voltage peaks, uncotrollble pulse width, etc. Another soft switching method ...

This paper presents a measurement circuit structure for capturing SET pulse-width suppressing pulse-width modulation and within-die process variation effects. For mitigating pulse-width modulation while maintaining area efficiency, the proposed circuit uses massively parallelized short inverter chains as a target circuit. Moreover, for each inverter chain on each die, pulse-width calibration is...

Abstract This paper presents a pulse electrical stress and measurement system of GaN high-electron-mobility transistors based on FPGA to apply the accurately in form square wave pulses switch measuring state time. The design processes for program, software system, hardware circuit are discussed. uses bipolar isolated gate driver HEMTs. mode is used from “stress mode” “measuring realize paramete...

This paper presents a new photonic integrated circuit, namely optical pulse-train generator, which is developed based on the transfer matrix analysis of microrings and utilizes a time-interleaved architecture. This circuit can generate multiple optical pulses sequentially from a single trigger pulse, with the timing and amplitude of each pulse determined by circuit design. Hence it can be appli...