A thermal via has been used to enhance the heat transfer through the printed circuit board (PCB). Because the thermal conductivity of a dielectric material is very low, the array of metal vias is placed to make thermal paths in the PCB. This paper describes the numerical analysis of the PCB having metal vias and focuses on the heat transfer characteristics under the nonisothermal boundary condi...

In the present study, the microstructure of welded zone of Hastelloy X sheets with thickness of 1 mm via pulsed Nd-YAG laser welding were studied. This welding process was done by autogenus and conductive method. Microstructure were observed by metallurgical OM and SEM. Results shown Solidification of the weld metal is dendritic. The dendrites in the central zone of the welding are fine and equ...

We examine the application of short-circuit electrical boundary conditions in density-functional theory calculations of ferroelectric thin films. Modeling PbTiO3 films with metallic electrodes, we demonstrate that under periodic boundary conditions of supercells, short-circuit conditions for the electrodes are equivalently satisfied in two repeated slab geometries: a PbTiO3/metal superlattice g...

In a mixture of metal ions and complexes, it is difficult to predict ecological risk without understanding the contribution of each metal species to biouptake. For microorganisms, the rate of uptake (internalization flux) has not only a major influence on the total metal flux but also on the bioavailability of the various metal species and their relative contributions to the total flux. In this...

In this paper, a general mode and theory of moving chelation boundary based isotachophoresis (MCB-based ITP), together with the concept of decisive metal ion (DMI) having the maximum complexation constant (lg Kmax) with the chelator, were developed from a multi-MCB (mMCB) system. The theoretical deductions were: (i) the reaction boundary velocities in the mMCB system at steady state were equal ...

We have studied the effects of grain boundary adhesion and grain size on the ductility of thin metal films well bonded to polymer substrates, using a finite element method. It is shown that the ductility of polymer-supported metal films increases approximately linearly as the grain boundary adhesion increases, and as the grain size decreases. A rule-of-thumb estimate of the ductility of polymer...

We give a formal derivation of an eeective nonlinear boundary condition associated with an electrostatic voltage potential on a corroding metal surface. Subsequently we use this boundary condition to analyze the determination of corrosion damage based on measurements of the boundary voltage potential and the associated current ux.

A novel 3ω thermal conductivity measurement technique called metal-coated 3ω is introduced for use with liquids, gases, powders, and aerogels. This technique employs a micron-scale metal-coated glass fiber as a heater/thermometer that is suspended within the sample. Metal-coated 3ω exceeds alternate 3ω based fluid sensing techniques in a number of key metrics enabling rapid measurements of smal...