due to the complex structure of the pressure-adjusting device used in most sprinklersfor variable irrigation, it is not possible to observe the flow behavior of the water passingthrough the flow field. in this paper, an integral three dimensional (3d) numerical modelbased on the structural characteristics of the fluidic sprinkler was constructed to simulatethe flow field distribution using comp...

the complete 3d nonlinear dynamic problem of extensible, flexible risers conveying fluid is considered. for describing the dynamics of the system, the newtonian derivation procedure is followed. the velocity field inside the pipe formulated using hydrostatic and bernoulli equations. the hydrodynamic effects of external fluids are taken into consideration through the nonlinear drag forces in var...

The single-phase flow and thermal performance of a double pipe heat exchanger are examined by experimental methods. The working fluid is water at atmospheric pressure. Temperature measurements at the inlet and outlet of the two streams and also at an intermediate point half way between the inlet and outlet is made, using copper-constantan thermocouple wires. Mass flow rates for each stream are ...

in order to increase the efficiency of the conveyance of the granular solids, a new experimental set-up is designed. the test rig has longitudinal trapezoidal slots in its conveying pipes. through experimentation, a correlation for friction factor in terms of solid mass flow rate, fluid flow rate and froude number is presented. it is shown that the mixture friction factor for pipes with inner t...

following recent works of several authors like huilgol, bhattacharya etd. and javadpour et al., this paper is to contribute further to the literature of axial flow in a rotational coaxial rheometer. we consider axial flow of herschel bulkley mode1 between two concentric cylinders with the inner one rotating, while the outer cylinder is held stationary. an attempt has been made to direct the ana...

In order to increase the efficiency of the conveyance of the granular solids, a new experimental set-up is designed. The test rig has longitudinal trapezoidal slots in its conveying pipes. Through experimentation, a correlation for friction factor in terms of solid mass flow rate, fluid flow rate and Froude number is presented. It is shown that the mixture friction factor for pipes with inn...

a theoretical solution is presented for the forced convection heat transfer of a viscoelastic fluid obeying the giesekus constitutive equation in a concentric annulus under steady state, laminar, and purely tangential flow. a relative rotational motion exists between the inner and the outer cylinders, which induces the flow. a constant temperature was set in both cylinders, in this study. the f...

Following recent works of several authors like Huilgol, Bhattacharya etd. and Javadpour et al., this paper is to contribute further to the literature of axial flow in a rotational coaxial rheometer. We consider axial flow of Herschel Bulkley mode1 between two concentric cylinders with the inner one rotating, while the outer cylinder is held stationary. An attempt has been made to direct the...

secondary flow investigation could be regarded as an important issue in open channel flow, in spite of its lower quantity compared to the base flow in the water course. it should be given special consideration because of the influence on some hydraulic factors in open channel, specifically in compound channels. in compound channels' due to the difference in the flow velocity of the main ch...