fiber metal laminates are hybrid laminates consisting of thin alternating bonded layers of aluminum and fiber/epoxy. arall (aramid aluminum laminate) and galare (glass fiber reinforced aluminum laminate) are specific kinds of fiber metal laminates that consist of thin aluminum sheets along with kevlar/epoxy and glass/epoxy composite layers, respectively. in this study, nonlinear tensile behavio...

An experimental study of the inelastic deformation of bulk metallic glass Zr41.2Ti13.8Cu12.5Ni10Be22.5 under multiaxial compression using a confining sleeve technique is presented. In contrast to the catastrophic shear failure (brittle) in uniaxial compression, the metallic glass exhibited large inelastic deformation of more than 10% under confinement, demonstrating the nature of ductile deform...

Investigated in this paper is the approximation in the ATC-40 nonlinear static procedure (NSP) that the earthquake-induced deformation of an inelastic single-degree-of-freedom (SDF) system can be estimated by an iterative method requiring analysis of a sequence of equivalent linear systems. Several deficiencies in the ATC-40 Procedure A are demonstrated. This iterative procedure did not converg...

[1] Using dynamic rupture models, we examine the response of compliant fault zones that surround pre‐existing faults to nearby earthquakes. We find that some portions of a compliant fault zone can experience inelastic deformation due to dynamic stress perturbations, while the remaining portions deform elastically. Inelastic response of the fault zone results in sympathetic fault‐parallel motion...

The mechanical properties of extracellular matrix proteins strongly influence cell-induced tension in the matrix, which in turn influences cell function. Despite progress on the impact of elastic behaviour of matrix proteins on cell-matrix interactions, little is known about the influence of inelastic behaviour, especially at the large and slow deformations that characterize cell-induced matrix...

torsion of many symmetric structures, which were designed based on the seismic codes, is due to their asymmetricity induced during inelastic behavior. although the structure was designed symmetrically assuming elastic based criteria, different factors such as material inconsistency in structure, construction details discrepancy and construction errors may result in asymmetric behavior in inelas...

Torsion of many symmetric structures, which were designed based on the seismic codes, is due to their asymmetricity induced during inelastic behavior. Although the structure was designed symmetrically assuming elastic based criteria, different factors such as material inconsistency in structure, construction details discrepancy and construction errors may result in asymmetric behavior in inelas...

Compaction bands are localized, planar zones of compressed material that form perpendicular to the maximum compressive stress. Compaction bands have been observed in porous sandstone formations in the field and in laboratory compression tests on porous sandstone, plaster, glass beads, polycarbonate honeycombs and metal foams. Because the permeability of the compacted material is much reduced, c...

An improved capacity-demand-diagram method that uses the well-known constantductility design spectrum for the demand diagram is developed and illustrated by examples. This method estimates the deformation of inelastic SDF systems consistent with the selected inelastic design spectrum, while retaining the attraction of graphical implementation of the ATC-40 Nonlinear Static Procedure.

This paper summarizes the lessons learned from a full-scale test on two RC frame prototypes that have recently been tested on LNEC shaking-table using four pairs of biaxial synthetic ground motion records during 15WCEE Conference (2012). The reference structures are two single-story RC frames which are geometrically identical but with different reinforcement details. The simplified inelastic mo...