Die corner filling is very important in tube hydroforming process. Definition of the internal pressure path is a key factor in improving the corner filling.  However, the factors that cause improvement of corner filling are still unclear. In this paper, effect of bilinear pressure path on corner filling in hydroforming of tube in box-shape die is studied using both finite element simulation and...

In this paper, the mechanism of improvement of formability in pulsating hydroforming of T-shape tubes is investigated by the finite element simulation and experiment. It is shown that local thinning was prevented by oscillating the internal pressure, because the protrusion is formed gradually by the prevention of sharp bulging. In the hydroforming, for the pulsating pressure, several steps occu...

Aluminum and magnesium alloys are of materials for decreasing vehicle weight and consequently reducing fuel consumption. However, forming limitations regarding their low formability at room temperature are found when being manufactured by conventional forming processes. For this reason, development of new forming techniques, such as warm tube hydroforming, is needed to overcome such limitations...

Micro-stamping process is one of the most cost-effective methods to manufacture metallic bipolar plates (BPPs). This research investigates the forming of titanium thin sheet as a potential candidate for BPPs in proton exchange membrane fuel cell (PEMFC). In this regard, the process was first simulated using finite element (FE) code Abaqus. Afterward, experimental tests were implemented and the ...

Deformation of the material during cyclic expansion extrusion (CEE) is investigated using upper-bound theorem. The analytical approximation of forming loads agrees very well with the FEM results for different amounts of chamber diameter, friction factor and also for lower die angles. However, the difference between analytical and numerical solution increases at higher die angles which are expla...

Strain distribution of Al 1100 was numerically investigated during cyclic expansion extrusion (CEE) process using finite element method (FEM). Die angle, corner fillet radius and die chamber diameter were considered as die parameters and friction factor and number of passes as process parameters. The effects of these parameters were investigated on the effective strain and strain homogeneity in...

In ultrasonic tube hydroforming, the tube is hydro formed while the ultrasonic vibration is applied to the die. Prior studies provide experimental proof that ultrasonic tube hydroforming reduces corner radius, improves lubrication and uniform thickness. Use of ultrasonic vibration can decrease friction at the tube-die interface. Few attempts have been made to analyze the wire drawing while the ...

Abstract: In this paper, the forming process of a central hub by radial-forward extrusion is analyzed by using the finite element software, ABAQUS. Radial-forward extrusion is used to produce hollow parts that generally feature a central hub with radial protrusions. Effective design factors such as mandrel diameter, die corner radius, die fillet radius, mandrel corner radius, tube wall thick...

The purpose of introducing ultrasonic vibrations in the tube hydroforming process is to create more formability by obtaining a lower corner radius, improve thickness distribution of the wall and provide good tribological conditions at the tube and the die interface. Vibrations imposed on the die create alternating gaps which improve the formability in the tube hydroforming process in the presen...