Considering the high consumption of the air compressors, a control system of screw compressor is designed and implemented to deal with energy saving and localization of mentioned compressor. In this paper the variable speed drive (VSD) control algorithm based on proportional-integral-derivative (PID) controller is optimized to decrease power consumption and more stable motor speed and outlet pr...

This paper describes a new design of low power 3-2 compressor circuit for high speed multipliers. Power consumption of proposed 3-2 compressor circuit varies from 0.355 nW to 1.6964 nW and delay varies from 2.0390 ns to 2.0224 ns. Further, power delay product of proposed circuit varies from 7.23×10 -18 (J) to 34.30×10 -18 (J) with varying supply voltage from 1.8V to 3.3V. The proposed compresso...

Designing multipliers that are of high-speed, low power, and regular in layout are of substantial research interest. Speed of the multiplier can be increased by reducing the generated partial products. Many attempts have been made to reduce the number of partial products generated in a multiplication process one of them is Wallace tree multiplier. Wallace Tree CSA structures have been used to s...

The Grasso RC12, introduced early 1996, belongs to the largest reciprocating compressors in industrial refrigeration. The high-speed variant, the RC12E, has been introduced in Europe by the end of 1997: the ammonia variant runs at 1500 rpm, whilst the halocarbon variant has a maximum speed of 1200 rpm. The design philosophy will be illustrated focusing on the valve design. The compressor housin...

Tris paper, through analy3is to the specific power of the compressor, indicates that to reduce the power loss caused by friction is an important way to reduce the specific power of the compressor, investigates the realizability employing a single piston ring or a piston ring with small elasticity in the high speed double acting compressor, and raises a standpoint for a high speed double acting ...

To ensure bearing reliability, it is traditional for compressor manufacturers to specify a minimum oil sump temperature difference above the saturated discharge temperature in a high-side compressor and suction temperature in a low-side compressor. This minimum oil sump temperature specification is, in essence, a surrogate measure of the minimum viscosity the compressor manufacturer reqtrires t...

Centrifugal compressors produce high pressure ratio and rotate at speeds. So, a tiny unbalance can produce severe vibration. In this paper, effects of impeller gap on rotor vibration in a high speed centrifugal compressor is investigated. For this purpose, a numerical and experimental analysis are carried out. The moving reference frame method in FLUENT software is used for modeling of geometri...

The effects of compressor speed variation on the heat transfer inside a speed controlled compressor were investigated in this study. Based on the lumped capacitance ntethod, the temperatures of the compressor components, the oil, and the refrigerant gas within the shell were modeled and simulated on a relative scale. A diffenmt heat transfer coefficient correlation was developed to evaluate the...

The adjustment and control mode of frequency conversion for an air-conditioner can make the refrigeration capacity adapt the variety of its load very well. Thus, it has many advantages such as low variety in in-door temperature, short time to reach the wished temperature, low energy consumption, low start electric current and low strike to electric source etc. This mode is widely used in room a...