the hydraulic pressure is one of the most important factors in the design of pressure intake tunnels. since the surrounding media cannot usually resist the high internal pressure of these tunnels, they are usually finished with an adequate lining mostly of reinforced concrete, which is an interaction problem between water, soil or rock and concrete lining. although reinforcing the concrete lini...

In the present study, ten steel-moment resisting frames (SMRFs) having different numbers of stories ranging from 3 to 20 stories and fundamental periods of vibration ranging from 0.3 to 3.0 second were optimized subjected to a set of earthquake ground motions using the concept of uniform damage distribution along the height of the structures. Based on the step-by-step optimization algorithm dev...

The hydraulic pressure is one of the most important factors in the design of pressure intake tunnels. Since the surrounding media cannot usually resist the high internal pressure of these tunnels, they are usually finished with an adequate lining mostly of reinforced concrete, which is an interaction problem between water, soil or rock and concrete lining. Although reinforcing the concrete lini...

One of the serious damages of tremendous earthquakes is the damage to bridges as the major components in an    arterial road network, as relief operation is interrupted following cutting roads. Regardless of the magnitude and severity of an earthquake, other factors are also important in the strength and seismic performance of concrete bridges. Freezing-thawing cycles are among the factors, whi...

in this paper, the effect on the strength properties of high strength concrete (hsc) manufactured with silica fume (sf) and ground pumice (gp) is investigated. portland cement was replaced with sf, gp and combination of sf and gp up to 25%. 22 different concrete mixtures with these replacement ratios were produced by using 0.25 water-binder ratio. the ultrasound pulse velocity, compressive, spl...

490 MRS BULLETIN/JULY 2002 nated by intergranular fracture, while in AJM it was in a manner resembling ductile behavior. Improved surface finishing by AJM resulted in a 15% improvement in flexural strength, compared with both ground and ground-plus-lapped samples. The researchers concluded that a higher compressive residual stress observed on the AJM-processed surface, combined with the smoothe...