PURPOSE The porcelain fused to gold has been widely used as a restoration both with the natural esthetics of the porcelain and durability and marginal fit of metal casting. However, recently, due to the continuous rise in the price of gold, an interest towards materials to replace gold alloy is getting higher. This study compared the bond strength of porcelain to millingable palladium-silver (P...

The mechanical properties of the Akers type clasp, bar and frame made by the newly developed Ti-20Cr-0.2Si alloy were studied in order to obtain the indices for designing the cast partial denture base. In the case of the clasp, the bending strength of the Ti-20Cr-0.2Si alloy and pure Ti was lower than that of the Co-Cr alloy. The Ti-20Cr-0.2Si alloy and pure Ti may have the same retentive force...

in this study, porcelain bond strength to three different alloys of gold-base, pd-ag and base-metal were compared and the effect of repeated porcelain sintering on bond strength was evaluated. the obtained results showed best bond strength of porcelain with gold-base alloy. pd-ag and base-metal alloys showed less strength respectively. during repeated sintering of porcelain, bond strength has n...

objectives: micromechanical retention of resin cements to alloys is an important factor affecting the longevity of metal base restorations. this study aimed to compare the bond strength and etching pattern of a newly introduced experimental etchant gel namely nano met etch with those of conventional surface treatment techniques for nickel-chrome (ni-cr) and high noble alloys.  materials and met...

This paper is a continuation of the project we presented at the 2010 Santa Fe Symposium® in which we defined a characterization system and analysis of data on 18K gold alloys. The research carried out since then has enabled us to connect the physical-mechanical characteristics of each alloy with its chemical composition, thereby identifying the best solution possible to produce a specific item....

The puprose of this study was to evaluate retention force of conical double crowns in two material connections: gold casting alloy/gold casting alloy and gold casting alloy/gold electroforming alloy. 12 crown pairs of both material connections with the cone angles of 2°, 4° and 6° were made. Experiment of 10.000 in-and-out cycles was performed using a new device which allows the retentive force...

The metals for porcelain fusing used in this study were gold alloys and nickel-chromium alloys. Chromatic characteristics were compared between samples of 0.1, 0.2 and 0.3 mm thickness. The dentin porcelain was fused on the opaque surface. Chromatic analyses were then carried out at each stage of 0.1 mm-incremental reductions of the dentin thickness starting from 0.5 mm. In conclusion, the meta...

Gold-silver alloy nanoparticles with varying mole fractions are prepared in aqueous solution by the coreduction of chlorauric acid HAuCl4 and silver nitrate AgNO3 with sodium citrate. As the optical absorption spectra of their solutions show only one plasmon absorption it is concluded that mixing of gold and silver leads to a homogeneous formation of alloy nanoparticles. The maximum of the plas...

The objective of this study was to investigate the joint properties between cast gold alloys and Co-Cr alloy laser-welded by Nd:YAG laser. Cast plates were fabricated from three types of gold alloys (Type IV, Type II and low-gold) and a Co-Cr alloy. Each gold alloy was laser-welded to Co-Cr using a dental laser-welding machine. Homogeneously-welded and non-welded control specimens were also pre...