Plastic worm wheel is widely used in the vehicle manufacturing field because it is favorable for weight lightening, vibration and noise reduction, as well as corrosion resistance. However, it is very difficult for general plastics to secure the mechanical properties that are required for vehicle gears. If the plastic resin is reinforced by glass fiber in the fabrication process of plastic worm ...

Strengthening of existing circular reinforced concrete columns by CFRP confinement

Glass fiber reinforced plastic composite materials are finding increased applications due to their excellent properties. Fiber reinforced plastic (FRP) composite materials comprise soft matrix and fiber elements. This article presents the tribological aspects of glass fiber reinforced plastic composites. The wear test is carried out for FRP in a pin-on-roller wear tester. The wear rate obtained...

the creep behavior of basalt fiber reinforced epoxy (bfre) and glass fiber reinforced epoxy (gfre) composites was studied through tensile testing at high temperature. to study the effect of reinforcing epoxy, the micro glass powder (mgp) was added at various volume percentage into the epoxy resin in bfre composites. the initial strain for all the specimens were evaluated and compared with each ...

Thermal non-destructive testing and evaluation of glass fibre reinforced plastic materials has gained more importance in aerospace industry due to low weight and high strength capabilities in severe environmental conditions. More recently, pulse compression favorable non-stationary excitation schemes have been exhibiting reliable defect detection capabilities in infrared non-destructive testing...

An automobile industry have an interest in replacement of conventional leaf spring with composite leaf spring to get better performance with less weight. This paper deals with by replacing the conventional leaf spring with composite leaf spring. The dimensions of an existing conventional steel leaf spring of a light commercial vehicle were taken to fabricate the special die which is further use...

Laser materials processing with ultra-short pulses allows very precise and high quality results with a minimum extent of the thermally affected zone. However, with increasing average laser power and repetition rates the so-called heat accumulation effect becomes a considerable issue. The following discussion presents a comprehensive analytical treatment of multi-pulse processing and reveals the...

We have developed an instrument for directly measuring the emissivity of reflective surfaces at near-millimeter wavelengths. The thermal emission of a test sample is compared with that of a reference surface, allowing the emissivity of the sample to be determined without heating. The emissivity of the reference surface is determined by one's heating the reference surface and measuring the incre...

The experimental investigations of the delamination factor of glass fiber reinforced plastic at different cutting parameters are reported in this study. This paper has involved the determination of different factors affecting the hole quality and cause of delamination in a glass fiber reinforced plastic. The various process parameters like different twist drill bits of different materails, diff...