frictional shear stress is usually determined by utilizing the coefficient of friction or the constant friction factor models. the present study deals with finite element analysis of double cup extrusion process to determine the relationship between constant friction factor (m) and coefficient of friction (µ), since the metal flow in this process is very sensitive to frictional conditions. ther...

This paper presents an experimental research on the distribution of local friction factor, fb, and global friction factor, f, over the cross-section of a channel with V-shaped bottom, which typically occurs in sewers and culverts. Several series of experiments were conducted for measuring velocity and boundary shear stress. It is found that, Darcy-Weisbach, f, is more sensitive than other resis...

factor  is introduced for direct head loss calculation and sizing in dual-diameter laterals of sprinkler and trickle irrigation systems when the hazen-williams equation is to be applied. application of this factor prevents trial and error and uses fewer head-loss equations in calculating the total friction loss and designing dual-diameter laterals. the proposed factor is a function of total num...

in order to increase the efficiency of the conveyance of the granular solids, a new experimental set-up is designed. the test rig has longitudinal trapezoidal slots in its conveying pipes. through experimentation, a correlation for friction factor in terms of solid mass flow rate, fluid flow rate and froude number is presented. it is shown that the mixture friction factor for pipes with inner t...

Response modification factors (R-factor) are used in current seismic building codes to reduce earthquake forces associated with seismic design level to determine force levels. In recent years, many authors have shown great interest in the development of seismic structural systems and several theoretical and experimental studies have been conducted to investigate performance of dampers but littl...

Frictional shear stress is usually determined by utilizing the coefficient of friction or the constant friction factor models. The present study deals with finite element analysis of double cup extrusion process to determine the relationship between constant friction factor (m) and coefficient of friction (µ), since the metal flow in this process is very sensitive to frictional conditions. Ther...

the thermo-hydraulic behavior of the air flow over a two dimensional ribbed channel wasnumerically investigated in various rib-width ratio configurations (b/h=0.5-1.75) atdifferent reynolds numbers, ranging from 6000 to 18000. the capability of differentturbulence models, including standard k-ε, rng k-ε, standard k-ω, and sst k-ω, inpredicting the heat transfer rate was compared with the experi...

Vortex extrusion (VE) is a severe plastic deformation technique which is based on the synergies between high strain accumulation and high hydrostatic pressure. Such a high amount of pressure, places a mandate to seek the method for investigation of the load under processing conditions. For this, kinematically admissible velocity field and upper bound terms based on Bezier formulation are develo...

The thermo-hydraulic behavior of the air flow over a two dimensional ribbed channel wasnumerically investigated in various rib-width ratio configurations (B/H=0.5-1.75) atdifferent Reynolds numbers, ranging from 6000 to 18000. The capability of differentturbulence models, including standard k-ε, RNG k-ε, standard k-ω, and SST k-ω, inpredicting the heat transfer rate was compared with the experi...

Metal-on-ultra-high molecular weight polyethylene (UHMWPE) total hip replacements have been the most popular and clinically successful implants to date. However, it is well documented that the wear debris from these prostheses contributes to osteolysis and ultimate failure of the prosthesis, hence alternative materials have been sought. A range of 28 mm diameter bearings were investigated using...