A series of tests on cold-formed steel foamed concrete (CSFC) composite walls subjected to axial load were proposed. The primary purpose of the experiments was to study the mechanical behavior and identify the failure modes of CSFC composite walls. Two main factors were considered in this study: 1) specimen with pouring foamed concrete or without and 2) different foamed concrete density ranks (...

Foamed mortar with a density of 1300 kg/m³ was prepared. In the initial laboratory trials, water-to-cement (w/c) ratios ranging from 0.54 to 0.64 were tested to determine the optimal value for foamed mortar corresponding to the highest compressive strength without compromising its fresh state properties. With the obtained optimal w/c ratio of 0.56, two types of foamed mortar were prepared, name...

Field trials have demonstrated that foamed gel is a very cost-effective technology for profile modification and water shut-off. However, the mechanisms of profile modification and flow behavior of foamed gel in non-homogeneous porous media are not yet well understood. In order to investigate these mechanisms and the interactions between foamed gel and oil in porous media, coreflooding and pore-...

The flexural behaviour of concrete containing Foamed glass as partial replacement of coarse aggregate is investigated. The coarse aggregate was replaced with 0%, 25%, 50%, 75% and 100% Foamed glass. All other constituents were maintained the same. Reinforced concrete beams were cast using 2 bars of 8mm in diameter in the tensile zone. The density and compressive strength of concrete decreased a...

This paper presents a comparative study of the characteristic of unfoamed and foamed geopolymers after exposure to elevated temperatures (200-800 °C). Unfoamed geopolymers were produced with Class F fly ash and sodium hydroxide and liquid sodium silicate. Porous geopolymers were prepared by foaming with hydrogen peroxide. Unfoamed geopolymers possessed excellent strength of 44.2 MPa and degrade...

Foamed alumina was previously synthesised by direct foaming of sulphate salt blends varying ammonium mole fraction (AMF), foaming heating rate and sintering temperature. The optimal product was produced with 0.33AMF, foaming at 100 °C/h and sintering at 1600 °C. This product attained high porosity of 94.39%, large average pore size of 300 µm and the highest compressive strength of 384 kPa. To i...

Asphalt pavement recycling has grown dramatically over the last few years as the preferred way to rehabilitate existing asphalt pavements. Rehabilitation of existing asphalt pavements has employed different techniques; one of them, cold in-place recycling with foamed asphalt (CIR-foam), has been effectively applied in Iowa. However, Iowa’s current cold in-place recycling (CIR) practice utilizes...

This chapter first describes the robotic CAM system proposed from the viewpoint of robotic servo controller for an industrial robot RV1A. Then, a reverse post-processor is proposed for the robotic CAM system to online generate the original CL data from the NC data post-processed for a five-axis NC machine tool with a tilting head. Next, an application of the industrial robot with incorporated t...

V. P. Karasyov, P. V. Kovalev, A. Z. Issagulov, V. Yu. Kulikov, Y. P. Chsherbakova. Saint-Petersburg State Polytechnic University, SaintPetersburg, Russia, Karaganda State Technical University, Karaganda, Kazakhstan There is considered the power operating mode of a high-power arc steelmaking furnaces (ASMF) in the period of the flat bath. It is revealed that electric energy is mainly spent for ...

Foam-mat drying is an alternative method which enables the removal of water from high-sugar content juices and purees that are difficult to dry. The aim of this study was to investigate the effect of different foam-mat drying methods on some physical properties and aroma of apple puree powder. Apple puree was foamed with the addition of foaming agents. Foamed puree was dried as a layer using di...