sandwich sheet rolling process is investigated using an analytical method (slab method) and a numerical method (finite element method). the horizontal stress distribution in the layers, the rolling pressure along the contact interface and the neutral point between the roll and the sheet are investigated. then the affects of the parameters such as the friction between the sheet and the roll, she...

In this paper, properties of slab deformation in sizing press mill as one of the slab reduction processes in hot rolling mills have been evaluated using the elastoviscoplastic finite element method with explicit formulation. Effect of prarameters such as initial slab width and thickness, reduction, feed pitch, and anvil speed on factors such as dogbone formation, head and tail fishtail profile,...

An approximation technique is considered for computing transmission and reflection coefficients for propagation of an elastic pulse through a planar slab of finite width. The propagation of elastic pulse through a planar slab is derived from first principles using straightforward time-dependent method. The paper ends with calculations of enhancement factor for the elastic plane wave and it is s...

In this paper, properties of slab deformation in sizing press mill as one of the slab reduction processes in hot rolling mills have been evaluated using the elastoviscoplastic finite element method with explicit formulation. Effect of prarameters such as initial slab width and thickness, reduction, feed pitch, and anvil speed on factors such as dogbone formation, head and tail fishtail profile,...

in this paper, based on the slab method of analysis, a novel and general approach isdeveloped for studying the radial forging process with curved profile dies. the presented approachis not only more general with respect to previous studies, but it is also easier to understand and useand can be efficiently used for optimization of the die profile depending on the forging geometryand conditions. ...

This study presents the results of an experimental program to investigate the effectiveness of an innovative combined FRP technique using combination of externally bonded (EB) FRP fabrics and near surface mounted (NSM) FRP rods for flexural strengthening of existing reinforced concrete (RC) two-wayslabs with low clear cover thickness. Three full-scale RC slabs (1500×1500×120 mm) were tested und...

We demonstrate the existence of surface waves in two-dimensional photonic crystal slab edges. In finite-sized air-terminated photonic crystal boundaries, the slab-edge mode turns into a lasing mode under pulsed optical pumping conditions. Analyses of the modal behaviors of the slab-edge modes by means of calculations based on the plane wave expansion method and the finite-difference time-domain...

slab method of analysis has been used for solving metal forming problems for a long time. however it has been restricted to plane strain and axisymmetric problems due to limitations in its formulations. in this paper a new formulation has been proposed so that it could be applied to three dimensional problems in metal forming. a parametric slab has been considered in this analysis and the force...

This study deals with the dynamic behavior of the kavar concrete Abstract face rockfill damwhich is the first dam of this type to be const ructed in a highly active seismic prone area,situated in the state of Fars southern part of the Islamic Republic of Iran. The finite elementmethod was used as a tool to carry out this study. The finite element discretization was carriedout under plane strain...

The casimir pressure on a non ideal conducting slab is calculated. Using a simple model for the conductivity according to which the slab is perfectly conducting at frequencies below plasma frequency ωp and perfectly transparent above such frequency, it is found that the vacuum pressure on each surface of the slab is h̄ω p 24πc which is finite without removal of any divergence.