In this work, the construction of a single stage L-band erbium-doped fiber amplifier which incorporates a short 5.1 m erbium doped fiber coil is described. Gain and noise figure measurements as a function of forward, backward and counter-propagating CW 1480 nm pumping schemes at different pump power levels are presented. Further, the Erbium Doped Fiber Amplifier (EDFA) power conversion efficien...

We propose and investigate experimentally a tunable and stable fiber laser with single-longitudinal-mode (SLM) and power-equalized output based on a two-stage erbium amplifier and a saturable-absorber filter. Two-stage amplifier consists of an erbium-doped waveguide amplifier (EDWA) and erbium-doped fiber amplifier (EDFA) to generate a flatter amplified spontaneous emission (ASE) source for con...

performance of the fiber optic networks with different physical topologies such as point-to-point, bus, ring and star, with respect to requirements as bit rates, topology structure, bit. error rate (ber) and optical component characteristics including optical amplifiers, filters, sources and detectors, are analyzed and simulated. for this purpose, maximum number of supportable nodes and throug...

This work describes the comparison of the amplification characteristics (gain) and the Noise figure (NF) of the Thulium and Erbium in three different host materials which the Yttria Alumina-Silica glass, Fluoride and Tellurite fiber glass. The gain using these host materials covers the range 1.45-1.65 μm. Thulium doped fiber amplifier (TDFAs) operated in the region of wavelength (1480-1510 nm) ...

• Understand the principle of operation of the erbium-doped fiber amplifier (EDFA). • Construct an EDFA and an erbium-doped fiber laser. • Measure and calculate the essential parameters of the constructed EDFA. The basic theories on optical amplification by erbium-doped fibers are presented in this section as preparation for the discussions on noise characteristics and noise reduction methods p...

We propose and demonstrate a novel sensor by using a single-fiber Bragg grating that can simultaneously measure strain and temperature with the aid of an erbium-doped fiber amplifier. By using a linear variation in the amplified spontaneous emission power of the erbium-doped fiber amplifier with temperature, we determine the temperature. By subtracting the temperature effect from the fiber Brag...

Raman amplification of a 49 cm Bismuth oxide (Bi2O3) as a nonlinear gainmedium based erbium doped fiber amplifier (EDFA) is reported in new and compactdesign in near infrared spectral regions. The bismuth glass host provides theopportunity to be doped heavily with erbium ions to allow a compact optical gain fiberamplifier design by using reduced fiber length and the 1480...

Erbium-doped fiber is a gain medium exhibiting homogeneous line broadening at room temperature, while a semiconductor optical amplifier has a dominant feature of inhomogeneous line broadening. In this work, a semiconductor optical amplifier is incorporated into the cavity of an erbium-doped fiber ring laser to form a hybrid gain medium. Theoretical analysis shows that such a gain medium support...

We successfully fabricate three-mode erbium doped fiber with a confined Er(3+) doped ring structure and experimentally characterize the amplifier performance with a view to mode-division multiplexed (MDM) transmission. The differential modal gain was effectively mitigated by controlling the relative thickness of the ring-doped layer in the active fiber and pump launch conditions. A detailed stu...