the micro milling operation is one of the manufacturing processes, which can produce 3d parts in the range of less than a millimetre. miniaturization of components results in increasing the ratio of surface area to volume of components, which in turn increases the role of surface on the component performance. therefore, anticipating the relationship between micro milling parameters and surface ...

in this paper, formation of wrinkling in bimetal deep drawing process has been investigated by the analytical, numerical and experimental methods. the effects of width of flange, fillet radii of matrix and punch, clearance of blank holder, contact conditions and relative thickness of two sheets on the number and height of wrinkle waves are studied. clearance and contact conditions have the grea...

determining characteristics and behavior of fluid flow and obtaining the aerodynamic coefficients are important and considerable tasks in investigation of flow over the bodies. in this research, leading edge radius effects on the flow behavior over a delta wing with a sweep angle of 50 degree at different reynolds numbers between 0.5×106 and 2.5×106 are investigated numerically. three different...

In this paper, we obtain some upper and lower bounds for the general extended energy of a graph. As an application, we obtain few bounds for the (edge) Zagreb energy of a graph. Also, we deduce a relation between Zagreb energy and edge-Zagreb energy of a graph $G$ with minimum degree $delta ge2$. A lower and upper bound for the spectral radius of the edge-Zagreb matrix is obtained. Finally, we ...

The concepts of critical and cocritical radius edge-invariant graphs are introduced. We prove that every graph can be embedded as an induced subgraph of a critical or cocritical radius-edge-invariant graph. We show that every cocritical radius-edge-invariant graph of radius r ≥ 15 must have at least 3r + 2 vertices.

In this paper, uniform and variable edge microgeometry design inserts are utilised and tested for 3D turning process. In 3D tool engagement with workpiece, thickness of the chip varies from a maximum equal to the feed rate (at primary cutting edge) to a minimum on the tool’s corner radius (at trailing cutting edge). The ideal tool edge preparation should posses a variable configuration which ha...

This paper investigates symmetrical buckling of orthotropic circular and annular plates of continuous variable thickness. Uniform compression loading is applied at the plate outer boundary. Thickness varies linearly along radial direction. Inner edge is free, while outer edge has different boundary conditions: clamped, simply and elastically restraint against rotation. The optimized RayLeigh-Ri...

Finite edge radius plays a significant role in finish machining processes when the undeformed chip thickness is often less than a few hundred microns and comparable to the size of the cutting edge. At suboptimal cutting speeds, edge radius tools may induce deeper subsurface plastic deformation, increase microhardness through work-hardening and mostly due to the ploughing of the cutting edge. On...