the design of microstrip antenna for improved bandwidth and directive gain is a challenge for researchers. This paper proposes the design of a Microstrip Square-Patch antenna with enhanced Bandwidth and Directive Gain. The design and simulation of this antenna has been done with the help of Ansoft HFSS. The simulated results give significant improvement in terms of directive gain and bandwidth....

Antenna 3D pattern measurement can be a tedious and time consuming task even for antennas with manageable sizes inside anechoic chambers. Performing onsite measurements by scanning the whole 4π [sr] solid angle around the antenna under test (AUT) is more complicated. In this paper, with the aim of minimum duration of flight, a test scenario using unmanned aerial vehicles (UAV) is proposed. A pr...

This paper presents a 1×4 array antenna using asymmetric T-shaped slit loaded microstrip antenna (MSA). The antenna consists of four MSAs align vertically on a dielectric substrate and ground plane. This antenna will be utilized in WLAN applications as the commercial panel antenna. A modified array configuration is proposed to further enhance the antenna radiation characteristics and usable ban...

Linear and planar antenna arrays are synthesized to have maximum directivity for a specified sidelobe level. The directivity is maximized subject to a given SLL. The beamwidth and the zeros of array factor are studied as well as the directivity. Maximum directivity-arrays are compared through some examples with super-directive, uniform, Dolph-Chebyshev and Riblet-Chebychev arrays to find a comp...

In this paper a novel biconical antenna geometry has been proposed that has directive radiation pattern, higher gain and enhanced front to back ratio. Wide band performance is another characteristic of this new antenna.

This master thesis has focused on the aspect of UWB antenna design for the impulse based UWB radar which is built on CMOS technology. The design of new UWB antenna faces some challenges. The antenna should be compact, preferably conformal, low cost for manufacture, and have good electrical performance, such as good matching, directional radiation performance over a wide band, good time response...

Abstract: In this paper a novel radial stub feeding microstrip bow-tie antenna is designed to operate between C and X band and its performance characterization is presented. This antenna is having simple structure and topology over other stub loaded antennas. In addition the proposed antenna adjusts to the desired frequency easily. Antenna output parameters like radiation pattern, axial ratio, ...

---This paper proposes a technique which improves Directivity and control of Beam-Steering by including metamaterial surfaces onto microstrip patch antenna superstrate used for wireless communication applications. Metamaterials are designed with Artificial Magnetic Conductor (AMC), inductive and capacitive planar structures. These structures allow obtaining Partially Reflective Surfaces (PRS). ...

In this paper, a directional GPS antenna for L1 frequency 1575 MHz with RHCP and a high directive gain is proposed for indoor positioning applications. The proposed antenna is made of a standard off the shelf GPS patch antenna with an additional conical reflector to enhance the gain and the beamwidth of the antenna. The angle of the cone reflector is optimized by HFSS 11 software. Finally, the ...