Abstract A wide variety of cutting fluids are commercially available in the cutting fluid suppliers in order to provide machining performances for a number of industries. In machining, mineral, synthetic and semi-synthetic cutting fluids are widely used but, recently, uses of vegetable based cutting fluids have been increased. Although, these cutting fluids are beneficial in the industries, the...

Parallel to the developments in the technology, a large number of cutting fluids were developed and used. Cutting fluids should contain suitable additions depending on the workpiece to be machined and the machining parameters. Their lubrication effects should be considered at the lower cutting speeds while their cooling effects should be considered at higher cutting speeds. In this study, descr...

The increasing attention to the environmental and health impacts of industrial activities by governmental regulations and by the growing awareness level in the society is forcing industrialists to reduce the use of mineral oil-based metalworking fluids as cutting fluid. Cutting fluids have been used extensively in metal cutting operations for the last 200 years. In the beginning, cutting fluids...

The application of conventional cutting fluids in machining operations is harmful and not eco-friendly. In this context, the present work focuses on environmental friendly cutting fluids such as vegetable oil based cutting fluids (VBCFs). The objective of this work is to determine the influence of vegetable oil based cutting fluids (sesame and coconut oil) with extreme pressure (EP) additive on...

In machining industry, cutting fluids have an important role due to their lubrication, cooling and chip removal functions. Using of cutting fluids can improve machining process efficiency, tool life, surface quality and it can reduce cutting forces and vibrations. However, health and environmental problems are encountered with the use of cutting fluids. Therefore, there has been a high demand f...

This paper presents the performance evaluation of three different cutting fluids used in a minimal quantity lubrication (MQL) system. The MQL system, developed in-house at the University of Malaya, was capable of delivering high velocity cutting fluid in narrow pulsed jet forms at a rate of 2 ml/min and a pressure of 20 MPa. The three cutting fluids chosen were neat oil, soluble oil and semi-sy...

In this study, two different vegetable based cutting fluids developed from refined canola and sunflower oil and a commercial type semi-synthetic cutting fluid were carried out to determine optimum conditions for tool wear and forces during milling of AISI 304 austenitic stainless steel. Taguchi L9 (3) orthogonal array was used for the experiment plan. Cutting speed, feed rate, depth of cut and ...

In the mid-1970s it was recognised that cutting fluids containing nitrites and amines may also contain N-nitrosoamines in concentrations between 200 and 30 000 ppm before dilution.' 2 Since many N-nitrosoamines are carcinogenic to animals3 cutting fluids containing these substances were withdrawn from the market in the late 1970s and the nitrites replaced with other substances. Even if there is...