co2 injection is an effective technique for improved oil recovery in light oil reservoirs, especially for water flooding abandoned reservoirs. in this study, the lower part of es1 reservoirs in pucheng oilfield was introduced as the target reservoir. by studying the minimum miscible pressure in co2 flooding, the reservoir could achieve miscible flooding. long core displacement experiments prove...

In this study, a benign process was used to successfully produce low density foam from poly(arylene ether sulfone) (PAES). Both carbon dioxide (CO2) and water as well as nitrogen and water were used as physical blowing agents in a one-step batch process. A large amount of blowing agents (up to 7.5%) was able to diffuse into the PAES resin in a 2-h saturation time. Utilizing water and CO2 as the...

Miscible gas injection, as an Enhanced Oil Recovery (EOR) method, can improve the recovery factor by swelling the residual oil and phasing out the interfacial tension [1]. However, the sweep efficiency of miscible gas injection is not satisfactory because of conformance problems, such as viscous fingering, channelling and gravity override [2]. Foam can solve the problems associated with gas inj...

this study aims to determine the effect of fermentation condition and saccharomyces strains on the ph, foam property and co2 concentration of non-alcoholic beer (ma-al-shaeer). for this, the beer samples were inoculated with four different species of saccharomyces (saccharomyces rouxii 70531, s. rouxii 70535, s. ludwigii 3447 and s. cerevisiae 70424) and fermented for 48h in both aerobic and pe...

In this study, carbon nano-fibers (CNFs) were used to increase the compressive properties of poly(arylene ether sulfone) (PAES) foams. The polymer composite pellets were produced by melt blending the PAES resin with CNFs in a single screw extruder. The pellets were saturated and foamed with water and CO2 in a one-step batch process method. Dynamic mechanical thermal analysis (DMTA) was used to ...

We have recently reported on the development of a biomimetic vein model to measure the performance of sclerosing foams. In this study we employed the model to compare the commercially-available Varithena(®) (polidocanol injectable foam) 1% varicose vein treatment (referred to as polidocanol endovenous microfoam, or PEM) with physician compounded foams (PCFs) made using different foam generation...

Among the issues raised by the globally ice-covered Earth, or a so-called ‘hard’ snowball–Earth scenario, one of the most important is to establish the CO2 threshold required for the deglaciation. This problem has been addressed using the Energy-Balance Model (or EBM), which showed that for Neoproterozoic insolation, 0.29 bar of CO2 would be needed to trigger deglaciation. New results, obtained...

A CO2 solid sorbent based on polyethyleneimine 10k (PEI-10k) impregnated into mesoporous silica (MPS) foam was synthesized and utilized to capture CO2 at temperatures ranged from 65 ̊C to 95 ̊C. The calculated nitrogen and carbon contents in the bulk of the PEI-10k/MPS sorbent were similar to the XPS results measured on the surface of the foam, suggesting that the PEI was homogeneously distribute...

Creation of foam structures from hydrolytically degradable poly(ε-caprolactone) (PCL) is a current task in biomaterial research. One example are degradable scaffolds. The thermodynamic and kinetic conditions in a supercritical CO2 (scCO2) supported foaming process of PCL can influence the resulting morphology of the foam. PCL-foaming with scCO2 was systematically investigated in the pressure ra...