Titanium carbide is used as an attractive reinforcement to produce particulate metal matrix composites. One of the problems to use this carbide as a reinforcement in copper-based composites is the lack of wetability in Cu-TiC system. This property improves as the C/Ti ratio in carbide decreases. Problems to use this carbide as a reinforcement in copper-based composites is the lack of wetabiity...

Fine-grained tungsten carbide copper (WC-Cu) cemented carbide was sintered via spark plasma sintering at 1773K using a fine WC powder with a mean particle size of 0.11 mm. The mechanical properties were compared with tungsten carbide cobalt (WC-Co) cemented carbide and a binderless WC-sintered material. The Vickers hardness and fracture toughness obtained by the indentation fracture method for ...

Titanium carbide is used as an attractive reinforcement to produce particulate metal matrix composites. One of the problems to use this carbide as a reinforcement in copper-based composites is the lack of wetability in Cu-TiC system. This property improves as the C/Ti ratio in carbide decreases.&#10Problems to use this carbide as a reinforcement in copper-based composites is the lack of wetabii...

Silicon carbide is one of the most promising materials for power electronic devices capable of operating at extreme conditions. The widespread application of silicon carbide power devices is however limited by the presence of structural defects in silicon carbide epilayers. Our experiment demonstrates that optical second harmonic generation imaging represents a viable solution for characterizin...

Our present work presents a direct association of the observed loss of shear strength in boron carbide under plane shock wave compression to amorphization in boron carbide under triaxial stress compression. This evidence is obtained from in-situ measurement of Raman, and infrared vibrational spectra of boron carbide confined in a Diamond Anvil Cell (DAC) under hydrostatic and non-hydrostatic pr...

Carbide composites are materials based on the carbide phases of the refractory or high melting temperature metals. The hard carbide phase (WC, TiC) is usually embedded into soft matrix – pure metals (Fe, Co, Mo, Ni and others) or their combinations. The hard phase supports high hardness and strength of the carbide composites, while matrix is needed for toughness and plastic properties. The ordi...

The inferred crystallographic class of circumstellar silicon carbide based on astronomical infrared spectra is controversial. We have directly determined the polytype distribution of circumstellar SiC from transmission electron microscopy of presolar silicon carbide from the Murchison carbonaceous meteorite. Only two polytypes (of a possible several hundred) were observed: cubic 3C and hexagona...

Nanocomposites films of (polymer blend-ceramics) were prepared from (PVA-PAA) blend and (PVA-PAA) blend doped with niobium carbide nanoparticles for humidity sensors have low cost, easy fabrication, high sensitivity, lightweight and high corrosion resistance. The structural, electrical and optical properties of (PVA-PAA-NbC) nanocomposites have been studied. The D.C electrical properties of (PV...