gas motion within the cylinder is one of the major factors that control the combustion process in spark ignition engine. it also has significant impact on heat transfer. both the bulk gas motion and the turbulence characteristics of the flow are important and governing the overall behavior of the flow. an arrangement for obtaining a stratified charge, using port injection, is proposed for a cur...

in this study it has been tried, to compare results and convergence rate of sensitivity analysis and conjugate gradient algorithms to reduce fuel consumption and increasing engine performance by optimizing the timing of opening and closing valves in xu7/l3 engine. in this study, considering the strength and accuracy of simulation gt-power software in researches on the internal combustion engine...

In this study it has been tried, to compare results and convergence rate of sensitivity analysis and conjugate gradient algorithms to reduce fuel consumption and increasing engine performance by optimizing the timing of opening and closing valves in XU7/L3 engine. In this study, considering the strength and accuracy of simulation GT-POWER software in researches on the internal combustion engine...

in this paper, the amount of wasted heat from different parts of a 12 liter compression ignition engine and their potential for waste heat recovery were investigated. then, two-stage configuration of organic rankine cycle was introduced for simultaneous heat recovery from exhaust gases and coolant. finally, parameters like hybrid generated power, engine thermal efficiency and brake specific fue...

one of the methods to reduce the emissions in a diesel engine is by oxygen introduction into the combustion chamber which can be done by supplying the oxygen into the inlet manifold during suction stroke. oxygen affects different parameters such as brake thermal efficiency, fuel consumption, nox and smoke at different load conditions. load test was conducted for various concentrations of oxygen...

The present study focuses on the effect of air-fuel ratio on the performance of four cylinder hydrogen fueled direct injection internal combustion engine. GT-Power was utilized to develop the model for direct injection engine. Air-fuel ratio was varied from rich limit to a lean limit. The rotational speed of the engine was varied from 1250 to 4500 rpm. The acquired results shown that the air fu...

AbstractStringent emission norms and environment degradation due to pollutants from the automotive vehicles lead us to find the suitable alternative for the petro-diesel. The oxygenated fuel used is dibutyl ether(DBE). While injection pressure is 200 bar and injection timing is 20.5 0 BTDC we get higher brake thermal efficiency and lower brake specific fuel consumption for DBE10 compare to diesel.

In this study, the effects of injection pressure and timing on the performance and emission characteristics of a DI diesel engine using methanol (5%, 10% and 15%) blended-diesel fuel were investigated. The tests were conducted on three different injection pressures (180, 200 and 220 bar) and timings (15 , 20 , and 25 CA BTDC) at 20 Nm engine load and 2200 rpm. The results indicated that brake s...

Due to diminishing petroleum reserves and the environmental negative effects of exhaust gases from diesel engines, alternative fuels for diesel engines are becoming increasingly important Egyptian waste cooking oils have special specifications because it expose to high temperatures during use for long hours. In the present experimental study, the performance and emissions of a four strokes, sin...