the purpose of this study is to improve the aerodynamic performance of wind turbine blades, using the ball-spine inverse design method. the inverse design goal is to calculate a geometry corresponds to a given pressure distribution on its boundaries. by calculating the difference between the current and target pressure distributions, geometric boundaries are modified so that the pressure differ...

in high-pressure axial turbines, when the fluid mass flow is low, the supersonic blades are being used to obtain a high specific work output. to prevent losses due to low blade aspect ratio, the turbine is used in partial admission conditions. the turbine stator is a group of convergence-divergence nozzles that provides the supersonic flow. the design of these nozzles is important, because ther...

This paper presents on-line tool breakage detection of small diameter drills by monitoring the AC servo motor current. The continuous wavelet transform was used to decompose the spindle AC servo motor current signal and the discrete wavelet transform was used to decompose the feed AC servo motor current signal in time–frequency domain. The tool breakage features were extracted from the decompos...

Intraosseous anesthesia is an effective and increasingly used technique with few reported complications. The technique uses a specialized drill to perforate the osseous cortex where local anesthetic can then be deposited to anesthetize teeth. It has been reported that separation of the perforation drills from their plastic bases can occur because of the friction generated during osseous perfora...

The manufacturing of chemical vapour deposition (CVD) diamond coated shaft type cutting tools is demanding due to the complex design of the cutting edges and the cobalt content of the cemented carbide. The influencing parameters of substrate, pre-treatment and diamond film on the tool cutting performance are discussed. The optimised manufacturing route of CVD diamond coated thread milling drill...

An isolated small wind turbine emulator based on a separately excited DC motor is developed to evaluate the performance of small wind turbine control strategies. The test rig consists of a 3HP separately excited DC motor coupled to a synchronous generator. A dump load is connected to the generator through a buck-boost converter controlled by a microcontroller. Wind turbine rotor and furling dyn...

We have developed a new wind turbine system that consists of a diffuser shroud with a broad-ring brim at the exit periphery and a wind turbine inside it. The shrouded wind turbine with a brimmed diffuser has demonstrated power augmentation by a factor of about 2–5 compared with a bare wind turbine, for a given turbine diameter and wind speed. This is because a low-pressure region, due to a stro...