In this study, polyamide-aluminum foil-polypropylene (PA-Al-PP) composite films with different orientation status of the PP layer were prepared, and their morphology, tensile, peeling and heat seal behavior were studied. The comparative study of tensile and fracture behaviors of single-layer film of PA, Al and PP, as well as the composite films of PA-Al, PP-Al and PA-Al-PP revealed that in PA-A...

abstractin this study, the tensile force requirement, to separate the grain paddy was measured. the velocities of grain paddy it 100, 200, 300, 400, and 500 mm/min, and force requirement to failure stem at 100, 300, and 500 mm/min velocities was measured by using instron device. the data was analyzed using a completely randomized design. the results showed that velocity had a significant effect...

BACKGROUND AND PURPOSE Several studies have shown that nicotine has a detrimental effect on the development of rotator cuff tear. However, little is known about its mechanism. We evaluated the effect of nicotine on the maximum tensile load, the maximum tensile stress, and the elastic modulus of the supraspinatus tendon in a rat model. METHODS 27 rats were randomly assigned to 3 groups. Subcut...

The tensile creep behavior is extremely important in crack prediction and stress analysis of concrete. The main objective is investigating the effects of the silica fume on the tensile basic creep of early-aged concrete. The effect of silica fume on tensile creep was studied using lever-type tensile creep tester. Silica fume amount by weight of total cementing material was 0%, 5%, 10% and 15%. ...

The concept that blood pressure influences vessel wall composition and structure is well established. Any alterations in stretch (caused by changes in blood pressure) solicit counteracting radial and tangential forces, driving transformations in the vessel wall that aim to accommodate the new conditions and to ultimately restore basal levels of tensile stress.1–3 Thus, when tensile stress incre...

Cavitation damage in flexure bars crept at 1170°C was studied by a density measurement technique. The cavity density within the flexure beams could be approximated by a linear function of position from the tensile surface. A threshold stress for cavitation damage is suggested from the results of this study. Below the threshold tensile stress, cavitation ceases, whereas above the threshold, cavi...

An in vitro study evaluated the effects of barrier materials on mechanical properties of a visible light-cured composite restorative. The composite was cured and aged over a widely used cavity liner (Dycal), various cements (Fleck's, Durelon, Vitrabond, ZOE B & T) and free eugenol and tested at seven and 28 days. The properties of interest were tensile stress (strength) at rupture, compressive ...

STATEMENT OF PROBLEM Selecting material for a minimally invasive occlusal veneer reconstruction concept requires an understanding of how stresses are distributed during functional and parafunctional forces. PURPOSE The purpose of this in vitro study was to investigate stress distribution in a maxillary molar restored with ultrathin occlusal veneers and subjected by an antagonistic mandibular ...

The Airy stress function for a long tensile fault of arbitrary dip and finite width buried in a homogeneous, isotropic, perfectly elastic half-space in welded contact with a homogeneous, orthotropic, perfectly elastic half-space are obtained. This Airy stress function is used to derive closed-form analytical expressions for the stresses at an arbitrary point of the half-space caused by along ve...

This paper investigates the effects of tube length and diameter on the distributions of tensile stress and interfacial shear stress of a single-walled carbon nanotube in epoxy matrix. It was shown that a smaller tube diameter has a more effective reinforcement and there exists an optimal tube length at which reinforcement is maximized. It was also found that a carbon nanotube has a greater stre...