The indentation deformation and cracking responses of ion-exchanged glasses were measured using quasi-static and dynamic loading cycles. Two glass types were compared, a normal glass that deforms to a large extent by a shearing mechanism and a damage-resistant glass that comparatively deforms with less shear and more densification. The quasi-static indentation cracking threshold for median/radi...

Cracking of laser hybrid welding of eccentric fillet joints has been studied for stainless steel. Laser hybrid welding enables narrow deep welds with freedom for shaping the upper weld geometry. The significance of geometrical aspects like weld toe radius, weld surface topography and lack of fusion on fatigue cracking is discussed. Constant amplitude four point bending tests, S/N-curve, topogra...

Results and Conclusion: The analysis results show that the cracking deflection of the prestressed, concrete beams increases with the increase in the porosity of the grouting material of the beams under different load forms. By contrast, under the same porosity grouting material, the cracking deflection of the symmetrical loads is larger than that of the uniform and concentrated loads. As the po...

ion of Models of Stress Corrosion Cracking of Drip Shield and Waste Package Outer Barrier and Hydrogen Induced Corrosion of Drip Shield TABLE OF CONTENTS Page 1. PU R P O SE ............................................................................................................................... 8 2. QUALITY ASSURANCE .............................................. 8 3. COMPUTER SOFTWARE AN...

Development of flexible sensors/electronics over substrates thicker than 100 μm is of immense importance for its practical feasibility. However, unlike over ultrathin films, large bending stress hinders its flexibility. Here we have employed a novel technique of fabricating sensors over a non-planar ridge topology under pre-stretched condition which not only helps in spontaneous generation of l...

Environmental stress cracking (ESC) is a phenomenon in which a plastic resin is degraded by a chemical agent while under stress, and it is the leading cause of plastic component failure. It is a solvent-induced failure mode, in which the synergistic effects of the chemical agent and mechanical stresses result in cracking. A recent study showed that 25% of plastic part failures are related to ES...

The mechanics of cracking in fiber-reinforced ceramic matrix composites (CMCs) under general loadings remains incomplete. The present paper addresses one outstanding aspect of this problem: the development of matrix cracks in unidirectional plies under shear loading. To this end, we develop a model based on potential energy differences upstream and downstream of a fully bridged steady-state mat...

Thermal cracking of kerogens and bitumens is widely accepted as the major source of natural gas (thermal gas). Decomposition is believed to occur at high temperatures, between 100 and 200 degrees C in the subsurface and generally above 300 degrees C in the laboratory. Although there are examples of gas deposits possibly generated at lower temperatures, and reports of gas generation over long pe...

Field observations of maturely slipped faults show a generally broad zone of damage by cracking and granulation. Nevertheless, large shear deformation, and therefore heat generation, in individual earthquakes takes place with extreme localization to a zone <1–5 mm wide within a finely granulated fault core. Relevant fault weakening processes during large crustal events are therefore likely to b...