A 132.70-m-high tower (above foundation) has been successfully completed at Tenerife Island. The foundation of the tower, a 2-mthick reinforced concrete slab, is supported by jointed, vesicular and weathered basalt, and scoria. A three-dimensional, elastic finite element program has permitted to calculate the displacements of the tower and the stresses in the slab. The installation of rod exten...

In this paper, an atomistic based finite element model is developed to investigate the influence of topological defects on mechanical properties of graphene. The general in-plane stiffness matrix of the hexagonal network structure of graphene is found. Effective elastic modulus of a carbon ring is determined from the equivalence of molecular potential energy related to stretch and angular defor...

objectives: nowadays, snap-fits are used in the automotive industry as a proper alternative for mechanical joints, cabling joints, and car interior lining joints. due to the special form of these joints, which are assembled manually, the contact area between snap-fits and the worker's fingertips can be too small. this can cause skin pain on the worker's fingertips. therefore, an ergonomic study...

A state-based peridynamic material model describes internal forces acting on a point in terms of the collective deformation of all the material within a neighborhood of the point. In this paper, the response of a state-based peridynamic material is investigated for a small deformation superposed on a large deformation. The appropriate notion of a small deformation restricts the relative displac...

The heel pad consists of a superficial microchamber layer and a deep macrochamber layer. This study highlights the different biomechanical behaviors between the microchamber and macrochamber layers using ultrasonography. The heel pad in each left foot of six healthy volunteers aged approximately 25 yr old was measured with a device consisting of a 10-MHz linear-array ultrasound transducer and a...

According to the geological characteristics of Xinjiang Ili mine in western area of China, a physical model of interstratified strata composed of soft rock and hard coal seam was established. Selecting the tunnel position, deformation modulus, and strength parameters of each layer as influencing factors, the sensitivity coefficient of roadway deformation to each parameter was firstly analyzed b...

The effect of modulus and film thickness on the release of adhered spores and sporelings (young plants) of the green fouling alga Ulva (syn. Enteromorpha) was investigated. PDMS elastomers of constant thickness (100 microm) but different elastic moduli were prepared by varying cross-link density with functional silicone oligomers with degrees of polymerization ranging from 18-830. This provided...

Elasto-plastic mechanical deformation behaviors of c-plane (0001) and nonpolar GaN single crystals are studied using nanoindentation, cathodoluminescence, and transmission electron microscopy. Nanoindentation tests show that c-plane GaN is less susceptible to plastic deformation and has higher hardness and Young's modulus than the nonpolar GaN. Cathodoluminescence and transmission electron micr...

In order to study the thallus changes on microscopic morphology and mechanical properties of Candida albicans antagonized by Streptococcus sanguinis bacteriocin, the adhesion ability and Young's modulus of thalli and hypha of Candida albicans were measured by the relative measurement method using atomic force microscope's (AFM) tapping model. The results showed that the average adhesion ability...