A sodium dodecyl sulfate modified carbon paste electrode (SDS/CPE) was developed in this work based on the surface modification method. The modified electrode was prepared by immersing SDS/CPE in a nickel nitrate solution. This electrode showed a strong accumulation ability toward nickel ions. Then modified electrode was conditioned by potential recycling in a potential range of 0.2–0.8 V (vs. ...

a thin film of epinephrine (ep) was electrochemically deposited on the surface of glassy carbon electrode previously activated in nahco3 solution. the cyclic voltammograms of the modified electrode indicate that the surface confined ep are strongly dependent on the solution ph, as expected for quinone/hydroquinone functionalities. the ep-modified glassy carbon electrode exhibited catalytic acti...

we used an effective electrochemical sensor for the determination of imipramine at ph 7.2 using a carbon nanocomposite electrode. the electrode has been designed by incorporation of montmorillonite nanoclay into the carbon ionic liquid electrode. the high sensitivity of 1.714 μa (μm)-1, two linear calibration ranges of 0.1–2 μm and 2-40 μm, and detection limit of 19 nm were achieved. the relati...

the glucose oxidase (gox) electrochemical sensors were used to detect a little amount of glucose. in this paper, the pure platinum plate (length of 5 cm and a width of 3 mm), the ag/agcl electrode and platinum electrode (diameter of 1 mm) were applied as a working electrode (w.e), reference electrode and auxiliary electrode sequential. factors measured, glucose concentration and ph is phosphate...

A modified electrode was prepared by modification of the carbon paste electrode (CPE) with graphene nano-sheets. The fabricated modified electrode exhibited an electrocatalytic activity toward gallic acid (GA) oxidation because of good conductivity, low electron transfer resistance and catalytic effect. The graphene modified CPE had a lower overvoltage and enhanced electrical current respect to...

the voltammetric performance of edge-plane pyrolytic graphite (epg) electrode via adsorptive stripping voltammetry was investigated for study of the electrochemical behavior of omeprazole (omz) in aqueous solution. the results revealed that the oxidation of omz is an irreversible ph-dependent process that proceeds with the transfer of one electron and one proton in an adsorption-controlled mech...

in order to study the cu(ii) ion selective electrode, an optimized membrane was prepared by mixing of 30 mg of pvc powdered, 5 mg of considered ionophore, 60 mg of plasticizer and 5 mg of additive. the sensor showed a near nernstian response for cu(ii) ions over a concentration range from 1.0×0-6 –1.0×0-2 m with a slope of 28.90.5 mv per concentration decade with a working ph range of 3.5-6.3. ...

a sensor, based on multi-wall carbon nanotubes modified glassy carbon electrode (mwcnt/gce), was developed for determination of fenitrothion. determining the surface area of mwcnt/gce showed that this surface is three times more active than that of a glassy carbon electrode. the experimental parameters, such as the amount of mwcnts, ph of the fenitrothion solution, preconcentration potential an...