The change in near-tip stress field in Small Scale Yielding (SSY) for cracks located at an interface between two materials with different plastic work hardening is investigated. The difference in hardening is termed hardening mismatch, and is quantified through the parameter n, which is the difference in hardening exponent between the two materials. For cracks in elastic-ideally plastic materia...

Drought stress is the main cause of mortality of holm oak (Quercus ilex L.) seedlings in forest plantations. We therefore assessed if drought hardening, applied in the nursery at the end of the growing season, enhanced the drought tolerance and transplanting performance of holm oak seedlings. Seedlings were subjected to three drought hardening intensities (low, moderate and severe) for 2.5 and ...

tunnelling through cities underlain by soft soil, commonly associated with soil movement around the tunnels and subsequent surface settlement. the predication of ground movement during the tunnelling and optimum support pressure could be based on analytical, empirical or the numerical methods. the commonly used earth pressure balance (epb) tunneling machines, uses the excavated soil in a pressu...

Strain hardening capability is critical for metallic materials to achieve high ductility during plastic deformation. A majority of nanocrystalline metals, however, have inherently low work hardening capability with few exceptions. Interpretations on work hardening mechanisms in nanocrystalline metals are still controversial due to the lack of in situ experimental evidence. Here we report, by us...

One solution to the high cost and scarcity of building materials is use alternative sustainable materials. The study presented herein developed an eco-friendly masonry grout using volumes palm oil clinker powder replace cement coarse aggregate. Several batches grouts with different amounts these were made determine technical viability grout. Scanning Electronic Microscope (SEM), X-Rays Diffract...

Abstract The development and construction of offshore wind farms requires the correct estimation friction that can be mobilised at rock/grout interface. In conventional studies, shear behaviour a joint is usually investigated with laboratory tests under constant normal load/stress (CNL), however, in engineering practice, direct testing stiffness (CNS) has been proved to more realistic assessmen...

The microstructural evolution during low temperature ageing of two commercial purity alloys (Al1.2Cu-1.2Mg-0.2Mn and Al-1.9Cu-1.6Mg-0.2Mn at.%) was investigated. The initial stage of hardening in these alloys is very rapid, with the alloys nearly doubling in hardness during 20 h ageing at room temperature. The microstructural evolution during this stage of hardening was investigated using diffe...

Based on experimental results, a dislocation material model describing the dynamic strain aging effect at different temperatures is presented. One and two stage loading tests were performed in order to investigate the influence of the loading direction as well as the temperature influence due to the hardening mechanism. Bergström’s theory of work hardening was used as a basis for the model deve...