The most popular friction law in metal forming applications is Tresca’s law which postulates that the friction stress is equal to a portion of the local shear yield stress. The friction factor involved in this law should be found from experiment. A typical test for this purpose is the ring compression test. The test must be supplemented with a theoretical analysis. The latter is often based on ...

We have measured the surface topography and calculated the surface roughness power spectrum for an asphalt road surface. For the same surface we have measured the friction for a tire tread compound for velocities 10(-6) m s(-1) < v < 10(-3) m s(-1) at three different temperatures (at -8 °C, 20 °C and 48 °C). The friction data was shifted using the bulk viscoelasticity shift factor a(T) to form ...

The Galerkin weighted residuals method is extended solve the laminar, fully developed flow and heat transfer of Al2O3-water nanofluid inside polygonal ducts with round corners for the constant heat flux and uniform wall temperature boundary conditions. Using the method, semi-analytical, closed-form solutions are obtained for the friction coefficient and the Nusselt number in terms of the radius...

–Friction stir welding is a solid state welding technology used for welding low melting point metals, such as Al, Mg and its alloys. Later welding was conducted on dissimilar metals which also produced a better defect free joint. Tool design and welding parameters contributes a major role for producing a better weld. Material flow and friction heat are the factors that the internal factor for t...

Single asperity friction experiments using atomic force microscopy (AFM) have been conducted on chemical vapor deposited (CVD) graphene grown on polycrystalline copper foils. Graphene substantially lowers the friction force experienced by the sliding asperity of a silicon AFM tip compared to the surrounding oxidized copper surface by a factor ranging from 1.5 to 7 over loads from the adhesive m...

1. Three men and seven women, 25-40 yr of age, were asked to use the thumb and index fingers to grasp, lift, and hold the armature of a linear motor generating a 2.0-N opposing force (simulating an object weighing approximately 200 g) for 2 s. The surface in contact with the fingers was composed of smooth or polyamide plastic etched with 1.0-mm high Braille beads separated at 2.0- or 3.0-mm int...

A review of the problem of aircraft skidding on Naval airfields during landings and a thorough literature search on the work conducted on friction coefficient were made. The literature search revealed that much ,vork has been conducted on basic theoretical studies of friction coefficient, on development of friction measuring devices, and on investigations to determine the factors which affect t...

This paper presents a theoretical study on the velocity distribution and the friction factor of boundary layer flows with polymer additives starting from the concept of “stress deficit.” A novel method of order of magnitude analysis is developed, which converts the governing equations of boundary layer flow into a solvable ordinary differential equation, thus the total shear stress distribution...

To demonstrate the influence of sliding friction of motion on a curve, a circular path is considered for simplicity on which a person slides from the highest point to the lowest point. A slide which represents a quadrant of radius 5 m and a person of mass 60 kg are considered for comparison in this paper. A Differential equation for motion considering the fact that the normal force depends both...