A new model for turbulent flame velocity of premixed flame in spark ignition engine for Iso-octane air mixture has been developed and validated for a wide range of engine operating parameters. The model developed is a zero dimensional thermodynamic model. The effects of engine speed (600-1160 rpm), equivalence ratio (0.7-1.1), unburnt mixture temperature (532650 Rankine), compression ratio (5-8...

Di methyl carbonate (DMC) has a lot of good properties to be used as a blend with gasoline. In order to improve the efficiency, combustion stability and emission performance of a spark ignition engine, oxygenated fuel (DMC) is added to a gasoline. In this experimental work, the effect of using 100% gasoline and gasoline-DMC blends (D5, D10, D15 and D20) on four cylinder engine performance and e...

In this work, number concentration and size distribution at the exhaust of a Port Fuel Injection (PFI) Spark Ignition (SI) engine downstream a three-way catalyst and a Direct Injection Common Rail Diesel engine have been measured with two particle size instruments. The gas exhaust is first diluted, a nano DMA is used to obtain the particles size distribution function in the 3-60 nm range, in pa...

Recent research in laser-induced ignition (LI) of air-fuel mixtures in internal combustion (IC) engines has shown there to be many potential advantages over conventional electrical spark ignition (SI). Spark plugs offer only limited possibilities for optimising engine efficiency, due to their fixed position within a cylinder and the protrusion of electrodes which disturb the cylinder geometry a...

The aim of this research is to study the influence of using ethanol-gasoline fuel blends on spark ignition engine performance characteristics and compare the obtained results with those using base gasoline. An electric generator operated by a SI (spark ignition, four stroke, single cylinder, air cooled) engine was used for conducting this study. The tested fuels were gasoline (E0) and gasoline-...

This paper presents the effect of friction on the performance of spark ignition engine using gas mixture as working fluid. The results were compared to frictionless engine. Engine parameters that were studied include equivalence ratio, engine speed, break mean effective pressure (BMEP), and cycle thermal efficiency. It was found for the frictionless engine operating at 6000 rev min and stoichio...

GENERATED NOISE IN IGNITION SYSTEMS High-frequency electromagnetic interference (EMI), commonly referred to as Radio Frequency Interference (RFI), generated by a gasoline engine ignition system, comes primarily from the high-voltage side of the circuit. Ignition systems produce sparks at the coil where the battery voltage is converted into high voltage pulses, at the distributor where the high ...

Ignition, flame propagation and stabilisation have been simulated and analysed in a turbulent jet of non-premixed methane and air. The first order Conditional Moment Closure (CMC) turbulent combustion model was fully coupled with a Reynolds-Averaged Navier Stokes (RANS) flow simulation. A CMC model was developed to account for spark ignition. The over-prediction of turbulent flame propagation w...

This paper investigates the effect of ethanol-unleaded gasoline blends (E0,E10,E25,E35,andE65) computer interfaced, four-stroke single cylinder compression ignition engine. The said engine wasconverted to spark ignition and carburetion to suit ethanol fuel. A suitable provision was provided on theengine to vary the compression ratio thereby making the engine adaptable to operate at lowercompres...

The ability of mean value models to replicate the key characteristics of automotive powertrains has been well established over the past four decades. There has been considerable success in the application of these models to controller design, with improved emissions and performance of the primary benefits. However, these low order models typically must make certain assumptions about the engine—...