0010-938X/$ see front matter 2013 Elsevier Ltd. All rights reserved. http://dx.doi.org/10.1016/j.corsci.2013.07.045 ⇑ Corresponding author. Address: Faculty of Mechanical Engineering and Naval Architecture, Departmet of Materials, Ivana Lučića 5, 10000 Zagreb, Croatia. Tel.: +385 1 616 8313; fax: +385 1 615 7126. E-mail address: [email protected] (L. Ćurković). Lidija Ćurković a,⇑, Helena ...

In the present work Taguchi method is used to optimize cutting parameters during dry turning of AISI 304 austenitic stainless steel with AlTiCrN coated tool. The coating was deposited on fine-grained K-grade (ISO K-20) cemented carbide cutting insert using physical vapor deposition (PVD) technique. The turning parameters evaluated are cutting speed of 200 and 260 m/min, feed rate of 0.20 and 0....

Stable ductile crack growth in 3 mm thick AISI 304 stainless steel specimens has been investigated experimentally and numerically. Multi-linear Isotropic Hardening method coupled with the Von-Mises yield criterion was adopted for modeling elasto-plastic behavior of the material. Mode-I CT fracture specimens have been tested to generate experimental load-displacement-crack growth data during sta...

The electrochemical behavior of the corrosion resistance AISI 304 embedded in concrete manufactured as indicated by ACI 211.1 method was evaluated. specimens were exposed for more than 150 days to highly aggressive marine-sulfated environment, solution with a concentration 5% NaCl and Na2SO4. technique Resistance Linear Polarization (Rp) used determine rate (Icorr) monitoring potential (Ecorr)....

In this research work a series of tests were conducted in order to determine flank wear and cutting force FY on hard AISI 440 C martensitic stainless steel and SCM 440 alloy steels. The operating parameters are cutting speed, feed rate and a constant depth of cut to investigate the flank wear and cutting force. No cutting fluid was used during the turning process. The cutting tool used was CBN ...

To measure the cleanability of stainless steel surfaces under standardized conditions, a test stand was set up. Three stainless steel plates (size 200 x 100 mm) can be fixed to the test stand and sprayed with a water jet from a low-pressure nozzle for a period of several minutes. The plates were previously soiled with a starch or protein film with a pre-defined layer thickness and dried for sev...