Nucleation and kinetics of defects at the atomic scale provide the most fundamental information about the mechanical response of materials and surfaces. Recent advances in experimental and computational analyses allow us to study this phenomenon in the context of nanoindentation and localized mechanical probing of surfaces. Here, we present an analytical formulation of the elastic limit that pr...

Articles you may be interested in The study of the mechanical properties of Au films by nanoindentation techniques AIP Conf. High magnetic field annealing effect on visible photoluminescence enhancement of TiO2 nanotube arrays Appl. Magnetic and mechanical properties of rolled-up Au/Co/Au nanomembranes with multiple windings Direct observation of twin deformation in YBa2Cu3O7− x thin films by i...

Elastic modulus of bone was investigated by nanoindentation using common methods of sample preparation, data collection, and analysis, and compared to dynamic mechanical analysis (DMA: three-point bending) for the same samples. Nanoindentation (Berkovich, 5 m and 21 m radii spherical indenters) and DMA were performed on eight wet and dehydrated (100% ethanol), machined equine cortical bone beam...

This study was aimed at elucidating the temporal changes of microarchitectural and mechanical parameters of cancellous bone in the osteoporotic rabbit model induced by ovariectomy (OVX) combined with glucocorticoid (GC) administration. Osteoporotic (OP) group received bilateral OVX combined with injections of GC, while sham group only received sham operation. Cancellous bone quality in vertebra...

OBJECTIVE The optimal polymerization of resin-based luting cements plays a critical role in the long-term clinical success of dental prostheses and indirect restorations. This study investigated a mutual action between the conformational changes and mechanical properties of a dimethacrylate resin-based luting cement with and without pre-application of the acidic functional monomer 10-methacrylo...

Nanoindentation has been recently used to measure the mechanical properties of polycrystalline graphene. However, the measured failure loads are found to be scattered widely and vary from lab to lab. We perform molecular dynamics simulations of nanoindentation on polycrystalline graphene at different sites including grain center, grain boundary (GB), GB triple junction, and holes. Depending on ...

Nanoindentation measurements were obtained on eight commercially-produced DP980 dual-phase steels to quantify the hardness of the individual constituents, ferrite and martensite, in each steel. Each microstructure was also evaluated to determine grain size, martensite volume fraction (MVF), and retained austenite content. Nanoindentation hardnesses and quantitative microstructural measurements ...

A viscoelastic nanoindentation technique was developed to measure both in-plane and through-thickness viscoelastic properties of human tympanic membrane (TM). For measurement of in-plane Young's relaxation modulus, the TM sample was clamped on a circular hole and a nanoindenter tip was used to apply a concentrated force at the center of the TM sample. In this setup, the resistance to nanoindent...

Nanoindentation of engineering materials is commonly used to study, at small length scales, the continuum mechanical properties of elastic modulus and yield strength. However, it is difficult to measure strain hardening via nanoindentation. Strain hardening, which describes the increase in strength with plastic deformation, affects fracture toughness and ductility, and is an important engineeri...

Nanoindentation has recently gained attention as a characterization technique for mechanical properties of biological tissues, such as bone, on the sub-micron level. However, optimal methods to characterize viscoelastic properties of bones are yet to be established. This study aimed to compare the time-dependent viscoelastic properties of bone tissue obtained with different nanoindentation meth...