In this paper, a 10-Gb/s inductorless CMOS receiver front end is presented, including a transimpedance amplifier and a limiting amplifier. The transimpedance amplifier incorporates Regulated Cascode (RGC), active-inductor peaking, and intersecting active feedback circuits to achieve a transimpedance gain of 56 dB and a bandwidth of 8.27 GHz with a power dissipation of 35 mW. The limiting amplif...

A CMOS self-biased fully differential amplifier is presented. Due to the self-biasing structure of the amplifier and its associated negative feedback, the amplifier is compensated to achieve low sensitivity to process, supply voltage and temperature (PVT) variations. The output common-mode voltage of the amplifier is adjusted through the same biasing voltages provided by the common-mode feedbac...

WSN is wireless sensor network which consist of numbers of nodes. Transceiver has main role in WSN node. Transceiver consists of both transmitter as well as receiver. Power amplifier, low noise amplifier, mixer, voltage control oscillator are the main block of Transceiver. Power amplifiers are a key part of RF transmitters. 2.4 GHz RF CMOS power amplifier implemented with SMIC 0.13μm is propose...

This paper describes the design of a fully differential CMOS amplifier for clipping control circuit. The amplifier with specification of low settling time less than 5ns, high dynamic range above 90dB and low power supply of 3 volt is designed and realized in a 0.35 μm CMOS process with 3 volt power supply. Simulation confirm the presented design.

Mann, David William: 90nm CMOS Driver Amplifier for WCDMA Mobile Applications (Under the direction of Dr. Kevin Gard.) Integration is driving today’s cellular phone industry to create single chip cellphone systems. With the integration of Radio Frequency Transmitters into CMOS technology, robust circuits are needed that can scale with new technologies. This thesis explores the challenges of des...

A 2.4-GHz single-stage CMOS low noise amplifier (LNA) structure with ultra low power consumption is proposed. A current reuse technique is used to decrease power dissipation with increasing amplifier transconductance for the LNA. Thus, the same amplifier transconductance for the LNA will be achieved at decreased power dissipation. Also, due to the use of an inverter-type amplifier which has a s...

The implementation of Low Noise Amplifier (LNA) front-ends is one of the challenging aspects in emerging Ultra Wide-Band (UWB) radio frequency (RF) systems. As it is highly desirable to achieve complete system-on-chip (SoC) integration, several CMOS based LNA implementations have been reported recently. The first part of this thesis presents a comparative study that helps designers understand t...

The Operational Amplifier (Op-Amp) is a fundamental building block in Mixed Signal design. Two stage Op-Amp is one of the most commonly used Op-Amp architectures. In this paper an operational amplifier by CMOS is presented whose input depends on bias current which is 30uA and designed using 1 um technology. In sub-threshold region due to unique behaviour of the MOS transistors not only allows a...

Abstract—In this paper, a CMOS differential operational transresistance amplifier (OTRA) is presented. The amplifier is designed and implemented in a standard umc90-nm CMOS technology. The differential OTRA provides wider bandwidth at high gain. It also shows much better rise and fall time and exhibits a very good input current dynamic range of 50 to 50 μA. The OTRA can be used in many analog V...