AbstractAn EMI Camera LSI (EMcam) with a 12 x 4 on-chip 250μm x 50μm loop antenna matrix in 65nm CMOS is developed. EMcam achieves both the 2D electric scanning and 60μm-level spatial precision for the first time. The down-conversion architecture increases the bandwidth of EMcam and enables the measurement of EMI spectrum. Shared IF block scheme is proposed to alleviate the increasing power and...

This paper proposes spread-spectrum clock modulation algorithms for EMI reduction in digitally-controlled DC-DC converters. In switching regulators using PWM, switching noise and harmonic noise concentrated in a narrow spectrum around the switching frequency can cause severe EMI. Spread-spectrum clock modulation can be used to minimize EMI. In conventional switching regulators using analog cont...

Three types of single-walled carbon nanotube (SWCNT) homogeneous epoxy composites with different SWCNT loadings (0.01–15%) have been evaluated for electromagnetic interference (EMI) shielding effectiveness (SE) in the X-band range (8.2–12.4 GHz). The effect of the SWCNT structure including both the SWCNT aspect ratio and wall integrity, on the EMI SE have been studied and are found to correlate...

A simple analytical model to predict the DC MOSFET behavior under electromagnetic interference (EMI) is presented. The model is able to describe the MOSFET performance in the linear and saturation regions under EMI disturbance applied to the gate. The model consists of a unique simple equivalent circuit based on a voltage dependent current source and a reduced number of parameters which can acc...

The large dv/dt and di/dt outputs of power devices in DC-fed motor drive systems in electric vehicles (EVs) always introduce conducted electromagnetic interference (EMI) emissions and may lead to motor drive system energy transmission losses. The effect of distributed parameters on conducted EMI from the DC-fed high voltage motor drive systems in EVs is studied. A complete test for conducted EM...

High-pressure infrared measurements were carried out to observe the microscopic structures of two imidazolium-based ionic liquids, i.e., 1-ethyl-3-methylimidazolium bis(trifluoromethylsulfonyl)amide [EMI(+)(CF(3)SO(2))(2)N(-), EMI(+)TFSA(-)] and 1-ethyl-3-methylimidazolium bis(fluorosulfonyl)amide [EMI(+)(FSO(2))(2)N(-), EMI(+)FSA(-)]. The results obtained at ambient pressure indicate that the ...

We have investigated the effect of pressure on imidazolium C-H---O interactions in 1-ethyl-3-methylimidazolium bis(trifluoromethylsulfonyl)amide (EMI(+)TFSA(-))/L64 and EMI(+)TFSA(-)/1,4-dioxane mixtures. The addition of Pluronic L64 to EMI(+)TFSA(-) leads to appreciable changes in band frequencies and shapes of the imidazolium C-H stretching bands. A possible explanation is the formation of C-...

Autophagy delivers cytosolic components to lysosomes for degradation and is thus essential for cellular homeostasis and to cope with different stressors. As such, autophagy counteracts various human diseases and its reduction leads to aging-like phenotypes. Macroautophagy (MA) can selectively degrade organelles or aggregated proteins, whereas selective degradation of single proteins has only be...

Piezoelectric ceramic Lead Zirconate Titanate (PZT) transducers, working on the principle of electromechanical impedance (EMI), are increasingly applied for structural health monitoring (SHM) in aerospace, civil and mechanical engineering. The PZT transducers are usually surface bonded to or embedded in a structure and subjected to actuation so as to interrogate the structure at the desired fre...

Fast switching in SMPS generate large amount of Electromagnetic Interference (EMI). The EMI consists of mainly common mode and differential mode noises. In the present work, conducted EMI is studied and a procedure for designing AC power line filter is proposed. As an application of this design procedure, conducted EMI noise measurement and filter design of a boost AC-DC converter with PFC has ...