Biocidal coatings that are based on quaternized ammonium copolymers were developed after blending and crosslinking and studied as a function of the ratio of reactive groups and the type of biocidal groups, after curing at room temperature or 120 ◦C. For this purpose, two series of copolymers with complementary reactive groups, poly(4-vinylbenzyl chloride-co-acrylic acid), P(VBC-co-AAx), and pol...

 provision of large, stress-bearing area  excellent fatigue strength  good shock absorption  reduced galvanic corrosion  no need to have access to far-side of adherend to make joint  bonding is possible on dissimilar materials  provision of smooth contours and sections around joint areas  sealing  improved damping which increases structural stiffness  reduction in distortion and metal...

This paper summarizes the results of an investigation on carbon dioxide (CO2) sequestration in concrete. Concrete mixtures were not air entrained. Concrete mixtures were made containing Class C fly ash at 0%, 18%, and 35% of total cementitious materials. Effects of three different curing environments on properties of concrete were studied: (1) moist-curing room with 100% relative humidity (RH) ...

changed under ambient condition for at least 40 h, time to which these measurements were carried out. To investigate the absorption behavior as a function of time, the absorption spectrum at 100 OC was taken at regular intervals over 40 h for poled/cured A204/DR1. An absorption peak at A, , = 508 nm existed before poling/curing. After poling/curing &shifta to 493 nm with a decrease of absorbanc...

In the electronics industry epoxy molding compounds, underfills and adhesives are used for the packaging of electronic components. These materials are applied in liquid form, cured at elevated temperatures and then cooled down to room temperature. During these processing steps residual stresses are built up resulting from both cure and thermal shrinkage. These residual stresses add up to the st...

Heat generation in an exothermic reaction during the curing process and low thermal conductivity of the epoxy resin produces high peak temperature and temperature gradients which result in internal and residual stresses, especially in large epoxy samples. In this paper, an optimization algorithm was developed and applied to predict the thermal cure cycle to minimize the temperature peak and the...

Epoxy nanocomposites of different content of carbon nanofibers upto 1 wt% have been fabricated under room temperature and refrigerated curing conditions. The composites were studied in terms of mechanical and electrical properties. Flexural modulus and hardness were found to increase significantly in refrigerated samples due to prevention of aggregates of nanofibers during cure condition. Incre...

OBJECTIVES Different light curing units are used for polymerization of composite resins. The aim of this study was to evaluate the degree of conversion (DC) and temperature rise in hybrid and low shrinkage composite resins cured by LED and Argon Laser curing lights. MATERIALS AND METHODS DC was measured using FTIR spectroscopy. For measuring temperature rise, composite resin samples were plac...

Alkali activated binders are a new class of binding material with comparable or enhanced performance to Portland cement. These binding materials are obtained by a chemical reaction between an alumino-silicate material and a highly alkaline solution. In most cases, the setting-hardening process of this binder is performed at high curing temperatures. In this paper, alkali activated mortars based...