Abstract: mechanical properties of AISIH 13 hot-work tool steel have been studied. Cast samples made of the modified new steel were homogenized and austenitized at different conditions, followed by tempering at the specified temperature ranges. Hardness, red hardness, three point bending test and Charpy impact test were carried out to evaluate the mechanical properties together with characteriz...

In industry, the cost of production is an important factor and it is preferred to use conventional and low cost procedures for producing the parts. Heat treatment cycles and alloying additions are the key factors affecting the microstructure and mechanical properties of the cast steels. In this study an attempt was made to evaluate the influence of minor Mo addition on the microstructure and me...

In the submitted paper the water disinfection capacity of the microalloyed aluminium based composite (MABC) was studied. MABC is material in the form of steel wire, plated with microalloyed aluminium. The effects of the composite are based on the very negative stationary potential of microalloyed aluminium, and its spontaneous dissolution in water with generation of AI(III) ions, and reduction ...

Abstract In this study, dual-phase (DP, ferrite + martensite) microstructures were obtained by performing intercritical heat treatments (IHT) at 750 and 800 °C followed quenching. Decreasing the IHT temperature from to leads to: (i) a decrease in volume fraction of austenite (martensite after quenching) 0.68 0.36; (ii) ~ 100 martensite start (Ms), mainly due higher carbon content its smaller gr...

A comprehensive set of models of precipitate formation during steel processing has been developed. In this work, it is applied to investigate Nb(C,N) precipitation in thin microalloyed steel slabs during continuous casting, reheating in a tunnel furnace and water quenching relative to the position with the slab and alloy content. The models include a transient heat-conduction and solidification...

microalloyed s355n steel plates are extensively used in bridge and high-rise building structures. one ofthe factors affecting the mechanical properties is the size and morphology of inclusions. in this research,microalloyed s355n steel plates with different sizes of inclusions were examined. one contained longmanganese sulfide inclusions (li material) and the other had short ones (si material)....

Ferrous metals include cast iron, steel, and the various steel alloys, The only difference between iron and steel is the carbon content. Cast iron contains more than 2-percent carbon, while steel contains less than 2 percent. An alloy is a substance composed of two or more elements. Therefore, all steels are an alloy of iron and carbon, but the term “alloy steel” normally refers to a steel that...

thermomechanical control process steel produced by rolling has a significant anisotropy. the elongated grains and inclusions formed during hot rolling of ferrite and low carbon hsla steels directly influence the anisotropy of the steel’s mechanical properties as a result of microstructural anisotropy. the present research deals with this anisotropy, and particular attention has been paid to the...

Microalloyed S355N steel plates are extensively used in bridge and high-rise building structures. One of the factors affecting the mechanical properties is the size and morphology of inclusions. In this research, microalloyed S355N steel plates with different sizes of inclusions were examined. One contained long manganese sulfide inclusions (LI material) and the other had short ones (SI materia...