The fct martensite morphology and the martensite transformation temperatures are examined for Pd-rich Fe–Pd–Pt alloys, which have the composition of Fe–(xPdyPt)xþy1⁄430 at:%. The replacement of Pd with Pt content causes solution hardening. The shape memory effects are investigated below the Af temperatures. Above the Af temperatures, the stress induced martensite in several grains completely di...

The two-way shape memory effect in a Ti36Ni49Hf15 high temperature shape memory alloy (SMA) has been systematically studied by bending tests. In the TiNiHf alloy, the martensite deformation is an effective method to get two-way shape memory effect even with a small deformation strain. When the TiNiHf alloy is deformed at a full martensite state, the deformation mechanism is the martensite orien...

Pseudoelasticity and the shape memory e ect (SME) due to martensitic transformation and reorientation of polycrystalline shape memory alloy (SMA) materials are modelled using a free energy function and a dissipation potential. Three di erent cases are considered, based on the number of internal state variables in the free energy: (1) Austenite plus a variable number of martensite variants; (2) ...

Utilizing electrical resistance measurements in combination with strain observations on single crystals, it was possible to distinguish the austenite to martensite transformation from the detwinning of the martensite behavior during deformation of NiTiCu shape memory alloys. It was found that the electrical resistance change associated with the detwinning of the martensite variants was as high ...

Stress-induced martensitic transformations are clarified in classes of NiMnGa alloys which undergo the stress-free, thermal-induced inter-martensite transformation austenite (A) pre-martensite (PM) martensite. This study implements a comprehensive experimental approach, including analysis of the strain–temperature and stress–strain response, which discloses stress-induced inter-martensite trans...

Calculations verify that carbon diffusion may occur during the lath martensite fomtion. Accordingly,the diffusion of int2rstitial ator ions must be taka into account nhfn martmitic transformtion is defined as a diffusionless transformation. In derivation of the kinetics equation of the ath& martensitic transfomtion,rzgardng the c a r h diffusion, i .e.the enrichment of the austenite during the ...

dual phase steels with different martensite volume fraction and morphology were tensile tested at a temperature range of 25 to 5500c. stress-strain curves of all steels showed serration flow at temperatures of 250 and 3500c, and smooth flow at the other temperatures. both yield and ultimate tensile strengths increased with increasing testing temperature up to about 4500c and then decreased at h...

in this study, the effects cold rolling and annealing parameters during thermomechanical processing of the aisi 201ln stainless steel were investigated. the cast samples were homogenized, hot-rolled and solution-annealed to acquire a suitable microstructure for the subsequent thermomechanical treatment. unidirectional and transverse multi-pass cold rolling at 25, 0 and -15 °c was carried out to...

Nanoindentation measurements were obtained on eight commercially-produced DP980 dual-phase steels to quantify the hardness of the individual constituents, ferrite and martensite, in each steel. Each microstructure was also evaluated to determine grain size, martensite volume fraction (MVF), and retained austenite content. Nanoindentation hardnesses and quantitative microstructural measurements ...

Strain-induced phase transformation and damage accumulation in austenitic stainless steel subjected to cyclic loading were investigated by nondestructive evaluation. The cyclic loading test was performed at various strain amplitudes at the same strain rate. The volume fraction of the strain-induced phase transformation (α′-martensite) was determined by ferrite scope and magnetic coercivity meas...