MgAlON composites have been prepared under nitrogen atmosphere, using Dengfeng calcined alumina w(Al2O3) = 85 % and other raw material, in order to reduce the production cost and make full use of the rich bauxite resources in Henan Province. The effects of the different sintering temperature and different matrix content on the preparation and properties of MgAlON composites were investigated. T...

A basic alumina-spinel low cement castable (LCC) composed of sintered bauxite, reactive alumina, calcined alumina, calcined magnesia, microsilica, and high alumina refractory cement was prepared (castable A) to which 5% sodium hexa-meta phosphate was later added (castable B) to prepare samples for heat treatment at 110ºC, 900ºC, and 1400ºC. Bulk Density (BD), Apparent Porosity (AP), and Cold Cr...

Alumina-zirconia (AZ) composites are attractive structural materials, which combine the high hardness and Young's modulus of the alumina matrix with additional toughening effects, due to the zirconia dispersion. In this study, AZ composites containing different amounts of zirconia (in the range 5-20 vol %) were prepared by a wet chemical method, consisting on the surface coating of alumina powd...

The influence of NaNO2, HNO3 and H2SO4 on the structure and morphology of gamma-alumina was investigated by XRD, BET, SEM and FT-IR spectroscopy. Selected amounts of NaNO2, HNO3 and H2SO4 were added to a solution of aluminum isopropoxide (as a precursor for the boehmite synthesis). The boehmite samples were calcined at 350 and 600 ℃ to form the semi-crystalline high surface area gamma-Al2O3. Th...

Sub-micron sized alumina fibres were fabricated by electrospinning and calcination of a polymer template fibre. In the calcination step, different controlled temperature heating cycles were conducted to obtain fibres of different crystalline structures. Their biodurabilities were tested at pH 7.4 with lung airway epithelial lining fluid or serum ultrafiltrate (SUF) and at pH 4.5 with macrophage...

Nowadays, magnesia carbon refractories are very important for the iron and steel industries. It is due to their unique properties, such as low wet ability with melt iron and steel. Therefore, it is important to extend the life of the refractory. In this research, the effect of calcined alumina and nano carbon on mechanical strength and corrosion resistance against slag in magnesia carbon refrac...

In the present investigation, γ-alumina nanoparticles with particle sizes less than 10 nm, high specific surface area (351 m2/g), high pore volumes and relatively narrow pore sizes distribution was prepared via sol-gel method in presence of aluminum isopropoxide as an aluminum precursor, distilled water, acetic acid as hydrolysis rate controller and tert-butanol as solvent. They had meso ...

X-ray photoelectron spectroscopy (XPS) technique was employed to characterize Al2O3-TiO2 support and MoO3/Al2O3TiO2 catalyst calcined at different temperatures from 773 to 1073 K. The Al2O3-TiO2 (1:1.3 mole ratio) binary oxide support was obtained by a coprecipitation procedure with in situ generated ammonium hydroxide. A nominal 12 wt.% MoO3 was impregnated over the calcined (773 K) support by...

We report on a recycling project in which α-Al(2)O(3) was produced from aluminum cans because no such work has been reported in literature. Heated aluminum cans were mixed with 8.0 M of H(2)SO(4) solution to form an Al(2)(SO(4))(3) solution. The Al(2)(SO(4))(3) salt was contained in a white semi-liquid solution with excess H(2)SO(4); some unreacted aluminum pieces were also present. The solutio...

Nanophase (Ce, Zr, Pr)O2-doped alumina coatings were prepared by impregnating the cordierite ceramic honeycomb in the sol or in the slurry of already calcined powder, respectively. The effects of preparation methods on the crystal phase, texture, oxygen storage capacity (OSC), reducibility, surface morphology and thermal stability of coatings were investigated by X-ray diffraction (XRD), the Br...