The influence of copper promoters and reaction conditions on the formation of alcohols byproducts of a common Fischer-Tropsch synthesis used iron-based catalysts were investigated. A good compromise of 28%Cu/FeKLaSiO2 can lead to the optimization of an improved Fischer-Tropsch catalyst. The product distribution shifts towards hydrocarbons with increasing the reaction temperature, while pressure...

Interareal connectomes are whole-brain wiring diagrams of white-matter pathways. Recent studies have identified modules, hubs, module hierarchies and rich clubs as structural hallmarks of these wiring diagrams. An influential current theory postulates that connectome modules are adequately explained by evolutionary pressures for wiring economy, but that the other hallmarks are not explained by ...

Owing to limitations of pump-and-treat, several technologies are being investigated for groundwater treatment. One of the most promising is the treatment of contaminants through the use of reactive barriers installed in situ, especially in the case of aquifers contaminated with chlorinated solvents. This work presents results of batch and column tests with metallic iron and some chlorinated sol...

In this work we evaluated the variability in fiber content and physical and chemical parameters of byproducts from orange juice extraction. Five different treatments and two drying methods were evaluated. The results indicate that drying by lyophilization was better than that drying in an oven. The pH ranged from approximately 3.47 to 3.96. The variation in moisture values was 9.22% ± 0.02 to 1...

A comparative study of three strategies used to synthesize well-defined carboxyl-end-capped polystyrenes is reported. Structural characterization was carried out using a combination of thin-layer chromatography (TLC) and matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOF MS). For the reaction of polystyryl anions with 4-bromo-1,1,1-trimethoxybutane, in addit...

Most of the methods adopted for processing of decayed fruits and degradation of wastes are not economical. In order to achieve 100% resource recovery from wastes, a novel type of waste treatment is to be followed, so that, the recovered byproducts could be used as biofertilizers. The objective of this study is identification of bacteria for studying their phenotypic and genotypic characters usi...

Green is the future of chemistry. Catalysts with high selectivity are the key to green chemistry. Polymer-supported Raney catalysts have been found to have outstanding performance in the clean preparation of some chemicals. For example, a polyamide 6-supported Raney nickel catalyst provided a 100.0% conversion of n-butyraldehyde without producing any detectable n-butyl ether, the main byproduct...

A microwave-assisted extraction (MAE) procedure to isolate phenolic compounds from almond skin byproducts was optimized. A three-level, three-factor Box-Behnken design was used to evaluate the effect of almond skin weight, microwave power, and irradiation time on total phenolic content (TPC) and antioxidant activity (DPPH). Almond skin weight was the most important parameter in the studied resp...

Dielectric barrier discharge (DBD) is an effective method to produce active species including ozone for remediation of pollutants in water, gas, etc. In the present work, a DBD type surface discharge system was utilised to degrade phenol in solutions. The influence of experimental conditions including solution pH values, initial concentration of phenol and applied voltage on the degradation rat...

Chromatography is a common step in the solution-phase synthesis of typical peptides, as well as peptide fragments for subsequent coupling on a solid support. Combining known reagents that form readily separable byproducts is shown to eliminate this step, which wastes time and other resources. Specifically, activating carboxyl groups with isobutyl chloroformate or as pentafluorophenyl esters and...