INTRODUCTION Since it is not possible to form an adequate micromechanical bond between resin cement and zirconia ceramics using common surface treatment techniques, laser pretreatment has been suggested for zirconia ceramic surfaces. The aim of this study was to evaluate the effect of Carbon Dioxide (CO2) Laser treatment on shear bond strength (SBS) of resin cement to zirconia ceramic. METHOD...

OBJECTIVES It is difficult to achieve adhesion between resin cement and zirconia ceramics using routine surface preparation methods. The aim of this study was to evaluate the effects of CO2 and Er:YAG laser treatment on the bond strength of resin cement to zirconia ceramics. MATERIALS AND METHODS In this in-vitro study 45 zirconia disks (6 mm in diameter and 2 mm in thickness) were assigned t...

PURPOSE The purpose of this in vitro research project was to evaluate and compare the wear behavior of human tooth enamel opposing monolithic zirconia and other different ceramic restorative materials and also to observe the tetragonal to monoclinic phase transformation in zirconia-based ceramics that may occur while simulating wear occurring at room temperature in a wet environment. MATERIAL...

We dedicate this work to Wolfgang Pompe, a very good friend and a good friend of the Materials Faculty at UCSB where he and his wife, Gisela, shared their lives and fellowship. Three different zirconia–alumina laminates, AZ50, AZ80, and AZ95, were fabricated via tape-casting thick Zr(3Y)O2 layers, dip-coating the zirconia tapes in a slurry containing a mixture of zirconia and alumina, stacking ...

Background: The introduction of translucent zirconia has improved mimetics: nevertheless, a reduction in the mechanical performance was registered. study aim to investigate characteristics high-translucent used for monolithic restorations before and after aging process compared low-translucent zirconia. Methods: A total 23 specimens were present study. Group (n = 10) made Y-TZP; group B 7) Y-TZ...

Equilibrium calculations were used to optimize conditions for the chemical vapor deposition (CVD) of zirconia. The results showed zirconia formation would occur at high oxygen to zirconium atomic ratios (N4), low hydrogen to carbon ratios (b10), low pressures (b105 Pa) and high temperatures (N800 °C). Using these calculations as a guide, single-phase monoclinic zirconia coatings were deposited ...

BACKGROUND Despite drawbacks, cold-cured acrylic resin is still the most common material used in denture repair. Zirconia nanoparticles were among the reinforcements added to increase the strength of the resin. The effect on Candida due to the addition of zirconia nanoparticles to the resin has not been investigated. PURPOSE The aim of this study was to evaluate the effect of zirconia nanopar...