This paper is concerned with the two-dimensional (2-D) linear-phase FIR notch filter-design problem. First, the singular value decomposition (SVD) is used to reduce the 2-D notch filter-design problem to two pairs of one-dimensional (1-D) filter design problems. Then, we derive an analytic least-squares solution for the design of two pairs of 1D linear-phase FIR filters. Again, the coefficients...

This paper proposes an algorithm for the suppression of narrow-band interference in direct sequence spread spectrum (DSSS) systems, based on the open loop adaptive IIR notch filtering. The center frequency of the interference is monitored on-line by the adaptive lattice IIR notch filter in [6] or by time-frequency analysis in [3]. The power of the interference signal is also estimated from the ...

This paper presents an experimental verification of ultra-wideband bandpass filter (BPF) for UWB applications and notch filter in order to suppress 5 GHz narrowband service when it coexists with UWB radio system. The BPF consists of a hexagonal shaped multiple mode resonator (MMR) with interdigital coupling at both sides. Notch filter is derived from BPF by introducing four embedded open stubs ...

In many signal processing applications, adaptive frequency estimation and tracking of noisy narrowband signals is often required in communications, radar, sonar, controls, biomedical signal processing, and the applications such as detection of a noisy sinusoidal signal and cancellation of periodic signals. In order to achieve the objective of frequency tracking and estimation, an adaptive finit...

Based on symmetry of the maximally flat frequency response of a FIR notch filter the new design procedure is developed. The closed form solution provides direct computation of the frequency response, recursive computation of the impulse response coefficients, simple windowing technique, and an access to new implementation. Several examples are included. INTRODUCTION In order to remove a single ...

In this paper, tunable microstrip bandpass filters with two TUNABLE BANDPASS FILTER SCHEMATIC AND OPERATION. Fig. 1 shows. A. Melloni, and F. Morichetti, “Tunable photonic circuits: a leap toward tunable microstrip bandpass filter using thin-film Barium-StrontiumTitanate (BST). -Electrical circuits and calculus class tutor (Sp 2013, Fa 2013). -Design tunable capacitors (varactors) and band-stop...

This brief is concerned with the two-dimensional (2-D) digital notch filter design problem. First, the outer product expansion is used to reduce the 2-D notch filter design problem to two pairs of one-dimensional (1-D) filter design problems. Then, we develop a simple algebraic method for the design of two pairs of 1-D IIR filter design. This approach not only has closed form transfer function ...

The study is concerned with a single-parameter adaptive comb filter (ACF), a multi-notch filter with periodically located nulls. The filter is suggested to retrieve a waveform modeled by superposition of harmonics, in particular, periodic non-sinusoidal signal. Using trigonometric constraints between the signal fundamental frequency and over tones results in a non-linear estimation problem. In ...

in this paper, effect of a single narrow-band interference (NBI) on bit error rate (BER) performance for a binary phase shift keying (BPSK) synchronous direct-sequence code-division multiple access (DS CDMA) communication system operating in a frequency nonselective Rayleigh fading channel is analyzed. Second-order adaptive infinite impulse response (IIR) notch filters with plain gradient algor...

In this paper, the two dimensional (2D) digital notch filter design problem is investigated. First, we develop a simple algebraic method for 2D IIR notch filter design. This approach not only has closed-form transfer function but also satisfies bounded input bunded output ( ~ 1 ~ 0 ) stability condition. Next, we use Lagrange multiplier method to design 2D FIR notch filters. This design is opti...